On Tue, May 09, 2017 at 08:21:17PM +0300, Andy Shevchenko wrote: > AVR32 is gone. Now it's time to clean up the driver by removing > leftovers that was used by AVR32 related code. > > Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> Acked-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxxxxxx> Thanks fo this cleanup. > --- > In v2: > - remove more leftovers of avr32 > drivers/mmc/host/Kconfig | 8 ++++---- > drivers/mmc/host/atmel-mci.c | 24 ++---------------------- > 2 files changed, 6 insertions(+), 26 deletions(-) > > diff --git a/drivers/mmc/host/Kconfig b/drivers/mmc/host/Kconfig > index 2db84dd664d7..e7d3b097cd30 100644 > --- a/drivers/mmc/host/Kconfig > +++ b/drivers/mmc/host/Kconfig > @@ -408,11 +408,11 @@ config MMC_AU1X > > config MMC_ATMELMCI > tristate "Atmel SD/MMC Driver (Multimedia Card Interface)" > - depends on AVR32 || ARCH_AT91 > + depends on ARCH_AT91 > help > - This selects the Atmel Multimedia Card Interface driver. If > - you have an AT32 (AVR32) or AT91 platform with a Multimedia > - Card slot, say Y or M here. > + This selects the Atmel Multimedia Card Interface driver. > + If you have an AT91 platform with a Multimedia Card slot, > + say Y or M here. > > If unsure, say N. > > diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c > index 388e4a3f13e6..2e96d964f582 100644 > --- a/drivers/mmc/host/atmel-mci.c > +++ b/drivers/mmc/host/atmel-mci.c > @@ -44,7 +44,7 @@ > #include <asm/unaligned.h> > > /* > - * Superset of MCI IP registers integrated in Atmel AVR32 and AT91 Processors > + * Superset of MCI IP registers integrated in Atmel AT91 Processor > * Registers and bitfields marked with [2] are only available in MCI2 > */ > > @@ -172,13 +172,6 @@ > #define atmci_writel(port, reg, value) \ > __raw_writel((value), (port)->regs + reg) > > -/* On AVR chips the Peripheral DMA Controller is not connected to MCI. */ > -#ifdef CONFIG_AVR32 > -# define ATMCI_PDC_CONNECTED 0 > -#else > -# define ATMCI_PDC_CONNECTED 1 > -#endif > - > #define AUTOSUSPEND_DELAY 50 > > #define ATMCI_DATA_ERROR_FLAGS (ATMCI_DCRCE | ATMCI_DTOE | ATMCI_OVRE | ATMCI_UNRE) > @@ -1549,21 +1542,8 @@ static void atmci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios) > mmc_regulator_set_ocr(mmc, mmc->supply.vmmc, ios->vdd); > break; > default: > - /* > - * TODO: None of the currently available AVR32-based > - * boards allow MMC power to be turned off. Implement > - * power control when this can be tested properly. > - * > - * We also need to hook this into the clock management > - * somehow so that newly inserted cards aren't > - * subjected to a fast clock before we have a chance > - * to figure out what the maximum rate is. Currently, > - * there's no way to avoid this, and there never will > - * be for boards that don't support power control. > - */ > break; > } > - > } > > static int atmci_get_ro(struct mmc_host *mmc) > @@ -2464,7 +2444,7 @@ static void atmci_get_cap(struct atmel_mci *host) > "version: 0x%x\n", version); > > host->caps.has_dma_conf_reg = 0; > - host->caps.has_pdc = ATMCI_PDC_CONNECTED; > + host->caps.has_pdc = 1; > host->caps.has_cfg_reg = 0; > host->caps.has_cstor_reg = 0; > host->caps.has_highspeed = 0; > -- > 2.11.0 > -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
