Commit 577fb13199b1 ("mmc: rework selection of bus speed mode")
refactored bus width selection code to mmc_select_bus_width().
However, it also altered the behavior to not call the selection code in
non-high-speed modes anymore.
This causes 1-bit mode to always be used when the high-speed mode is not
enabled, even though 4-bit and 8-bit bus are valid bus widths in the
backwards-compatibility (legacy) mode as well (see e.g. 5.3.2 Bus Speed
Modes in JEDEC 84-B50). This results in a significant regression in
transfer speeds.
Fix the code to allow 4-bit and 8-bit widths even without high-speed
mode, as before.
Tested with a Zynq-7000 PicoZed 7020 board.
Signed-off-by: Anssi Hannula <anssi.hannula@xxxxxxxxxx>
Cc: Seungwon Jeon <tgih.jun@xxxxxxxxxxx>
Cc: <stable@xxxxxxxxxxxxxxx>
Fixes: 577fb13199b1 ("mmc: rework selection of bus speed mode")
---
drivers/mmc/core/mmc.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index b61b52f9..0fccca0 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -1706,10 +1706,10 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
err = mmc_select_hs400(card);
if (err)
goto free_card;
- } else if (mmc_card_hs(card)) {
+ } else {
/* Select the desired bus width optionally */
err = mmc_select_bus_width(card);
- if (err > 0) {
+ if (err > 0 && mmc_card_hs(card)) {
err = mmc_select_hs_ddr(card);
if (err)
goto free_card;
--
2.8.3
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
