Add support for switching to DDR mode for eMMC devices. Although the host controller only supports 3.3 Volt and DDR52 uses 1.8 Volt according to the specification it is possible to use DDR also with 3.3 Volt for eMMC chips. To switch to DDR mode MMC_CAP_1_8V_DDR is required. Signed-off-by: Jan Glauber <jglauber@xxxxxxxxxx> Signed-off-by: David Daney <david.daney@xxxxxxxxxx> Signed-off-by: Steven J. Hill <steven.hill@xxxxxxxxxx> --- drivers/mmc/host/cavium-mmc.c | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) diff --git a/drivers/mmc/host/cavium-mmc.c b/drivers/mmc/host/cavium-mmc.c index 3d3c9c7..8fcb82a 100644 --- a/drivers/mmc/host/cavium-mmc.c +++ b/drivers/mmc/host/cavium-mmc.c @@ -858,6 +858,10 @@ static void cvm_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios) break; } + /* DDR is available for 4/8 bit bus width */ + if (ios->bus_width && ios->timing == MMC_TIMING_MMC_DDR52) + bus_width |= 4; + slot->bus_width = bus_width; if (!ios->clock) @@ -1091,8 +1095,14 @@ int cvm_mmc_slot_probe(struct device *dev, struct cvm_mmc_host *host) /* Set up host parameters */ mmc->ops = &cvm_mmc_ops; + /* + * We only have a 3.3v supply, we cannot support any + * of the UHS modes. We do support the high speed DDR + * modes up to 52MHz. + */ mmc->caps |= MMC_CAP_MMC_HIGHSPEED | MMC_CAP_SD_HIGHSPEED | - MMC_CAP_ERASE | MMC_CAP_CMD23 | MMC_CAP_POWER_OFF_CARD; + MMC_CAP_ERASE | MMC_CAP_CMD23 | MMC_CAP_POWER_OFF_CARD | + MMC_CAP_3_3V_DDR; if (host->use_sg) mmc->max_segs = 16; -- 2.9.0.rc0.21.g7777322 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
