On 10/01/17 09:00, Ritesh Harjani wrote:
> This provides enhanced_strobe mode feature support in sdhci-msm
> driver.
>
> Signed-off-by: Ritesh Harjani <riteshh@xxxxxxxxxxxxxx>
Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>
> ---
> drivers/mmc/host/sdhci-msm.c | 34 +++++++++++++++++++++++++---------
> 1 file changed, 25 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
> index fa9bce3..f958697 100644
> --- a/drivers/mmc/host/sdhci-msm.c
> +++ b/drivers/mmc/host/sdhci-msm.c
> @@ -103,6 +103,7 @@
>
> #define CORE_DDR_200_CFG 0x184
> #define CORE_CDC_T4_DLY_SEL BIT(0)
> +#define CORE_CMDIN_RCLK_EN BIT(1)
> #define CORE_START_CDC_TRAFFIC BIT(6)
> #define CORE_VENDOR_SPEC3 0x1b0
> #define CORE_PWRSAVE_DLL BIT(3)
> @@ -547,6 +548,7 @@ static void msm_hc_select_hs400(struct sdhci_host *host)
> {
> struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
> struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host);
> + struct mmc_ios ios = host->mmc->ios;
> u32 config, dll_lock;
> int rc;
>
> @@ -560,7 +562,8 @@ static void msm_hc_select_hs400(struct sdhci_host *host)
> * Select HS400 mode using the HC_SELECT_IN from VENDOR SPEC
> * register
> */
> - if (msm_host->tuning_done && !msm_host->calibration_done) {
> + if ((msm_host->tuning_done || ios.enhanced_strobe) &&
> + !msm_host->calibration_done) {
> config = readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC);
> config |= CORE_HC_SELECT_IN_HS400;
> config |= CORE_HC_SELECT_IN_EN;
> @@ -734,6 +737,7 @@ static int sdhci_msm_cdclp533_calibration(struct sdhci_host *host)
>
> static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host)
> {
> + struct mmc_host *mmc = host->mmc;
> u32 dll_status, config;
> int ret;
>
> @@ -748,6 +752,12 @@ static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host)
> */
> writel_relaxed(DDR_CONFIG_POR_VAL, host->ioaddr + CORE_DDR_CONFIG);
>
> + if (mmc->ios.enhanced_strobe) {
> + config = readl_relaxed(host->ioaddr + CORE_DDR_200_CFG);
> + config |= CORE_CMDIN_RCLK_EN;
> + writel_relaxed(config, host->ioaddr + CORE_DDR_200_CFG);
> + }
> +
> config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG_2);
> config |= CORE_DDR_CAL_EN;
> writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG_2);
> @@ -782,6 +792,7 @@ static int sdhci_msm_hs400_dll_calibration(struct sdhci_host *host)
> {
> struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
> struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host);
> + struct mmc_host *mmc = host->mmc;
> int ret;
> u32 config;
>
> @@ -795,14 +806,17 @@ static int sdhci_msm_hs400_dll_calibration(struct sdhci_host *host)
> if (ret)
> goto out;
>
> - /* Set the selected phase in delay line hw block */
> - ret = msm_config_cm_dll_phase(host, msm_host->saved_tuning_phase);
> - if (ret)
> - goto out;
> + if (!mmc->ios.enhanced_strobe) {
> + /* Set the selected phase in delay line hw block */
> + ret = msm_config_cm_dll_phase(host,
> + msm_host->saved_tuning_phase);
> + if (ret)
> + goto out;
> + config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
> + config |= CORE_CMD_DAT_TRACK_SEL;
> + writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
> + }
>
> - config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
> - config |= CORE_CMD_DAT_TRACK_SEL;
> - writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
> if (msm_host->use_cdclp533)
> ret = sdhci_msm_cdclp533_calibration(host);
> else
> @@ -899,6 +913,7 @@ static int sdhci_msm_execute_tuning(struct sdhci_host *host, u32 opcode)
>
> /*
> * sdhci_msm_hs400 - Calibrate the DLL for HS400 bus speed mode operation.
> + * This needs to be done for both tuning and enhanced_strobe mode.
> * DLL operation is only needed for clock > 100MHz. For clock <= 100MHz
> * fixed feedback clock is used.
> */
> @@ -909,7 +924,8 @@ static void sdhci_msm_hs400(struct sdhci_host *host, struct mmc_ios *ios)
> int ret;
>
> if (host->clock > CORE_FREQ_100MHZ &&
> - msm_host->tuning_done && !msm_host->calibration_done) {
> + (msm_host->tuning_done || ios->enhanced_strobe) &&
> + !msm_host->calibration_done) {
> ret = sdhci_msm_hs400_dll_calibration(host);
> if (!ret)
> msm_host->calibration_done = true;
>
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
