The capabilities of the SDHCI host controller are read early during the
SDHCI host initialisation in sdhci_setup_host() and before any
regulators for the host have been requested. This means that if the host
supports some high-speed modes (according to its capabilities register),
but the board cannot because the appropriate voltage regulator is not
available, then the host cannot easily override the capabilities that
are supported.
To allow a SDHCI host controller to determine if it can support high
speed modes via the presense of the MMC regulators, request the
regulators before reading the capabilites of the host controller. This
will allow the SDHCI host to use the 'reset' callback to take the
appropriate action (set flags, configure registers, etc) before the
capabilities register(s) are read.
Please note that some SDHCI hosts, such as the Tegra SDHCI host, has
the ability to mask bits in the capabilities register to prevent
certain capabilities from being advertised.
Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx>
---
Although this is described as a "V2" this patch has been added since
the original patch was posted.
If the below is deemed not appropriate, then another solution I was
thinking of is to allow the SDHCI host to call 'mmc_regulator_get_supply'
before calling sdhci_setup_host() and then in sdhci_setup_host() check
if any regulators are already present before calling
mmc_regulator_get_supply().
drivers/mmc/host/sdhci.c | 16 +++++++++++-----
1 file changed, 11 insertions(+), 5 deletions(-)
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 2ee8bfa77116..628c4b3558c0 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -3021,6 +3021,17 @@ int sdhci_setup_host(struct sdhci_host *host)
mmc = host->mmc;
+ /*
+ * If there are external regulators, get them. Note
+ * this must be done early before resetting the host
+ * and reading the capabilities so that the host can
+ * take the appropriate action if regulators are not
+ * available.
+ */
+ ret = mmc_regulator_get_supply(mmc);
+ if (ret == -EPROBE_DEFER)
+ return ret;
+
sdhci_read_caps(host);
override_timeout_clk = host->timeout_clk;
@@ -3253,11 +3264,6 @@ int sdhci_setup_host(struct sdhci_host *host)
mmc_gpio_get_cd(host->mmc) < 0)
mmc->caps |= MMC_CAP_NEEDS_POLL;
- /* If there are external regulators, get them */
- ret = mmc_regulator_get_supply(mmc);
- if (ret == -EPROBE_DEFER)
- goto undma;
-
/* If vqmmc regulator and no 1.8V signalling, then there's no UHS */
if (!IS_ERR(mmc->supply.vqmmc)) {
ret = regulator_enable(mmc->supply.vqmmc);
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
