Hi,
I am currently working on a design using i.MX6SL and Linux Kernel 3.14.52. Though I believe may question still applies to latest MMC code.
Our design uses an eMMC as boot device and main storage (ie: it contains u-boot, kernel, dtb and rootfs).
The eMMC I/O rail is fixed in hardware to 1.8Volts.
The Processor SDIO I/O rail is controlled by the MMC driver.
In 3.14.52, the MMC driver sets processor SDIO rail to 3v3 per default, and only when using HS DDR modes (which do not apply in our case) would it set it to 1.8V.
I have seen that starting on 3.16, the function power_up() in drivers/mmc/core/core.c attempts at setting the regulator to 3v3, failing that it tries 1v8, failing that it tries 1v2.
So I patched my kernel with that, and defined a fixed regulator with 1v8 in my dts, and set the vqmmc-supply to point to it.
But that doesn't work, because power_up() ultimately tries to call set_voltage() on the vqmmc regulator, which doesn't seem to exist for "regulator-fixed" type of regulators, and hence it fails in setting all the rails, which ultimately means that it sets it to 3v3 ('cause that is the default/initial value of the field in the ios struct)
So my question is: how am I supposed to setup the MMC driver in my scenario (I/O at 1.8V always) ?
(I know I can go and force the rail to 1.8V by hacking drivers/mmc/host/sdhci-esdhc-imx.c, but I would very much prefer to avoid that)
Thanks ,
Raul.
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
