Hi Shawn, On 03/07/2016 06:35 PM, Shawn Lin wrote: > Hi Jaehoon, > > On 2016/3/7 8:53, Jaehoon Chung wrote: >> Hi Goudong, >> >> On 03/06/2016 05:47 PM, Guodong Xu wrote: >>> Add resets property to synopsys-dw-mshc bindings. It is intended to >>> represent the hardware reset signal present internally in some host >>> controller IC designs. >>> >>> See Documentation/devicetree/bindings/reset/reset.txt for details. >>> >>> Signed-off-by: Guodong Xu <guodong.xu@xxxxxxxxxx> >>> Acked-by: Rob Herring <robh@xxxxxxxxxx> >>> --- >>> Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt | 4 ++++ >>> 1 file changed, 4 insertions(+) >>> >>> diff --git a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt >>> index 8636f5a..4e00e85 100644 >>> --- a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt >>> +++ b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt >>> @@ -39,6 +39,10 @@ Required Properties: >>> >>> Optional properties: >>> >>> +* resets: phandle + reset specifier pair, intended to represent hardware >>> + reset signal present internally in some host controller IC designs. >>> + See Documentation/devicetree/bindings/reset/reset.txt for details. >> >> Is this reset property for common dwmmc IP controller? > > I think so. By discussion with my ASIC team, it's provided by synopsys. > From dw_mmc databook version 270a, section 3.2.5, FBE Scenarios: > > An FBE occurs due to an AHB error response on the AHB bus. This is a > system error, so the software driver should not perform any further > programming to the DWC_mobile_storage. The only recovery mechanism > from such scenarios is to do one of the following: > ■ Issue a hard reset by asserting the reset_n signal > ■ Do a program controller reset by writing to the CTRL[0] register > > the reset_n signal can be used to reset all the internal logic block > with dwmmc and reset the register value to default stat. > > Note: reset_n is a internal signal, which is diff from rst_n for mmc hw > reset. (refer to databook section 5.2 Signal Descriptions, table 5-1) Thanks for this information. :) > >> >> Best Regards, >> Jaehoon Chung >> >>> + >>> * clocks: from common clock binding: handle to biu and ciu clocks for the >>> bus interface unit clock and the card interface unit clock. >>> >>> >> >> >> >> > > -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
