On 02/25/2016 01:18 PM, Vishal Thanki wrote:
[...]
Suspend or Runtime suspend?
The it is the runtime suspend routine for omap_hsmmc.c
mmc1_pins: pinmux_mmc1_pins {
pinctrl-single,pins = <
0x0fc 0x38 /* MMC0_DAT0 */
0x0f8 0x38 /* MMC0_DAT1 */
0x0f4 0x38 /* MMC0_DAT2 */
0x0f0 0x38 /* MMC0_DAT3 */
0x100 0x38 /* MMC0_CLK */
0x104 0x38 /* MMC0_CMD */
0x88 0x07 /* GPMC_CSN3 -> GPIO2_0 */
>;
};
mmc1_sleep_pins: pinmux_mmc1_sleep_pins {
pinctrl-single,pins = <
0x0fc 0x3f /* MMC0_DAT0 */
0x0f8 0x3f /* MMC0_DAT1 */
0x0f4 0x3f /* MMC0_DAT2 */
0x0f0 0x3f /* MMC0_DAT3 */
0x100 0x3f /* MMC0_CLK */
0x104 0x3f /* MMC0_CMD */
0x88 0x17 /* GPMC_CSN3 -> GPIO2_0 PULL UP */
>;
};
mmc1_cirq_pin: pinmux_cirq_pin {
pinctrl-single,pins = <
0x0f8 0x3f /* MMC0_DAT1 as GPIO2_28 */
>;
};
wlan0_pwrseq: pwrseq {
compatible = "mmc-pwrseq-simple";
reset-gpios = <&gpio2 0 GPIO_ACTIVE_LOW>;
clocks = <&clk_32768_ck>;
clock-names = "ext_clock";
};
&mmc1 {
status = "okay";
pinctrl-names = "default", "idle", "sleep";
pinctrl-0 = <&mmc1_pins>;
pinctrl-1 = <&mmc1_cirq_pin>;
pinctrl-2 = <&mmc1_sleep_pins>;
interrupts-extended = <&intc 64 &gpio2 28 0>;
^^ you can define IRQ type here
&gpio2 28 IRQ_TYPE_LEVEL_LOW
ti,non-removable;
bus-width = <4>;
vmmc-supply = <&ldo2_reg>;
vmmc_aux-supply = <&vmmc>;
keep-power-in-suspend;
enable-sdio-wakeup;
mmc-pwrseq = <&wlan0_pwrseq>;
};
Is there any other suggestion for mwifiex that I should try out? Or
is there any way in omap_hsmmc to specify the wakeup interrupt
type (IRQF_TRIGGER_LOW) while using generic wakeup IRQ
mechanism. I could not find it, but I may be missing something.
How your irqs defined in DT? Could you provide mmc+wifi nodes?
[..]
--
regards,
-grygorii
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
