mmc2 has a special pin for eMMC hardware reset, which is controllable
from the controller. Add the "mmc-cap-hw-reset" property to denote that
this controller supports this function, and the pins are actually used.
Also increase the signal drive strength for mmc2 pins, for HS-DDR mode
support.
Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
---
arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts b/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts
index 13ce68f06dd6..bd2a3beb4629 100644
--- a/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts
+++ b/arch/arm/boot/dts/sun8i-a33-sinlinx-sina33.dts
@@ -109,10 +109,13 @@
vmmc-supply = <®_vcc3v0>;
bus-width = <8>;
non-removable;
+ cap-mmc-hw-reset;
status = "okay";
};
&mmc2_8bit_pins {
+ /* Increase drive strength for DDR modes */
+ allwinner,drive = <SUN4I_PINCTRL_40_MA>;
/* eMMC is missing pull-ups */
allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
};
--
2.7.0.rc3
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
