This patch add some macros for HCON register operations
to make code more readable.
Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx>
---
Changes in v7: None
Changes in v6: None
Changes in v5: None
Changes in v4: None
Changes in v3: None
Changes in v2: None
drivers/mmc/host/dw_mmc.c | 6 +++---
drivers/mmc/host/dw_mmc.h | 3 +++
2 files changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
index 9c91983..0a3c63c 100644
--- a/drivers/mmc/host/dw_mmc.c
+++ b/drivers/mmc/host/dw_mmc.c
@@ -2678,7 +2678,7 @@ static void dw_mci_init_dma(struct dw_mci *host)
* Check ADDR_CONFIG bit in HCON to find
* IDMAC address bus width
*/
- addr_config = (mci_readl(host, HCON) >> 27) & 0x01;
+ addr_config = SDMMC_GET_ADDR_CONFIG(mci_readl(host, HCON));
if (addr_config == 1) {
/* host supports IDMAC in 64-bit address mode */
@@ -3060,7 +3060,7 @@ int dw_mci_probe(struct dw_mci *host)
* Get the host data width - this assumes that HCON has been set with
* the correct values.
*/
- i = (mci_readl(host, HCON) >> 7) & 0x7;
+ i = SDMMC_GET_HDATA_WIDTH(mci_readl(host, HCON));
if (!i) {
host->push_data = dw_mci_push_data16;
host->pull_data = dw_mci_pull_data16;
@@ -3142,7 +3142,7 @@ int dw_mci_probe(struct dw_mci *host)
if (host->pdata->num_slots)
host->num_slots = host->pdata->num_slots;
else
- host->num_slots = ((mci_readl(host, HCON) >> 1) & 0x1F) + 1;
+ host->num_slots = SDMMC_GET_SLOT_NUM(mci_readl(host, HCON));
/*
* Enable interrupts for command done, data over, data empty,
diff --git a/drivers/mmc/host/dw_mmc.h b/drivers/mmc/host/dw_mmc.h
index 811d467..f2a88d4 100644
--- a/drivers/mmc/host/dw_mmc.h
+++ b/drivers/mmc/host/dw_mmc.h
@@ -154,6 +154,9 @@
#define DMA_INTERFACE_GDMA (0x2)
#define DMA_INTERFACE_NODMA (0x3)
#define SDMMC_GET_TRANS_MODE(x) (((x)>>16) & 0x3)
+#define SDMMC_GET_SLOT_NUM(x) ((((x)>>1) & 0x1F) + 1)
+#define SDMMC_GET_HDATA_WIDTH(x) (((x)>>7) & 0x7)
+#define SDMMC_GET_ADDR_CONFIG(x) (((x)>>27) & 0x1)
/* Internal DMAC interrupt defines */
#define SDMMC_IDMAC_INT_AI BIT(9)
#define SDMMC_IDMAC_INT_NI BIT(8)
--
2.3.7
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
