The STOP command can terminate a data transfer between a memory card and
mmc controller.
As show in Synopsys DesignWare Cores Mobile Stroage Host Databook:
Data timeout and Data end-bit error will terminate further data transfer
by mmc controller. So we should not send abort command to terminate a
data transfer again if we got DRTO and EBE interrupt.
After this patch, all mmc_test cases can pass on RK3288-Pink2 board.
Signed-off-by: Addy Ke <addy.ke@xxxxxxxxxxxxxx>
---
drivers/mmc/host/dw_mmc.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
index 4d2e3c2..4bd7df1 100644
--- a/drivers/mmc/host/dw_mmc.c
+++ b/drivers/mmc/host/dw_mmc.c
@@ -1520,7 +1520,10 @@ static void dw_mci_tasklet_func(unsigned long priv)
if (test_and_clear_bit(EVENT_DATA_ERROR,
&host->pending_events)) {
dw_mci_stop_dma(host);
- send_stop_abort(host, data);
+ if (data->stop ||
+ !(host->data_status & SDMMC_INT_DRTO) ||
+ !(host->data_status & SDMMC_INT_EBE))
+ send_stop_abort(host, data);
state = STATE_DATA_ERROR;
break;
}
@@ -1547,7 +1550,10 @@ static void dw_mci_tasklet_func(unsigned long priv)
if (test_and_clear_bit(EVENT_DATA_ERROR,
&host->pending_events)) {
dw_mci_stop_dma(host);
- send_stop_abort(host, data);
+ if (data->stop ||
+ !(host->data_status & SDMMC_INT_DRTO) ||
+ !(host->data_status & SDMMC_INT_EBE))
+ send_stop_abort(host, data);
state = STATE_DATA_ERROR;
break;
}
--
1.8.3.2
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
