Hi Sonny/Doug, On Mon, Oct 6, 2014 at 11:23 PM, Sonny Rao <sonnyrao@xxxxxxxxxxxx> wrote: > We've already got a reset of DMA after it's done. Add one before we > start DMA too. This fixes a data corruption on Rockchip SoCs which > will get bad data when doing a DMA transfer after doing a PIO transfer. > > We tested this on an Exynos 5800 with HS200 and didn't notice any > difference in sequential read throughput. > > Signed-off-by: Sonny Rao <sonnyrao@xxxxxxxxxxxx> > Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx> > --- > drivers/mmc/host/dw_mmc.c | 4 ++++ > 1 file changed, 4 insertions(+) > > diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c > index 69f0cc6..2b5401e 100644 > --- a/drivers/mmc/host/dw_mmc.c > +++ b/drivers/mmc/host/dw_mmc.c > @@ -83,6 +83,7 @@ struct idmac_desc { > #endif /* CONFIG_MMC_DW_IDMAC */ > > static bool dw_mci_reset(struct dw_mci *host); > +static bool dw_mci_ctrl_reset(struct dw_mci *host, u32 reset); > > #if defined(CONFIG_DEBUG_FS) > static int dw_mci_req_show(struct seq_file *s, void *v) > @@ -448,6 +449,9 @@ static void dw_mci_idmac_start_dma(struct dw_mci *host, unsigned int sg_len) > > dw_mci_translate_sglist(host, host->data, sg_len); > > + /* Make sure to reset DMA in case we did PIO before this */ > + dw_mci_ctrl_reset(host, SDMMC_CTRL_DMA_RESET); > + Though this is good to do, but this does not look complete to me. dw_mmc data book does mention that " It is recommended that the host issue reset to DMA interface by setting DMA_RESET bit of the CTRL register and then issue a IDMAC software reset." The above lines are from 'Transmission and reception with internal DMA' section of the data book. My suggestion here to add dw_mci_idmac_reset() call after this above change. What is the controller version used in your case? > /* Select IDMAC interface */ > temp = mci_readl(host, CTRL); > temp |= SDMMC_CTRL_USE_IDMAC; > -- > 1.8.3.2 > > -- > To unsubscribe from this list: send the line "unsubscribe linux-mmc" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- Regards, Alim -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html