Re: "Card stuck in programming state! __mmc_switch" problem on i.MX6 + eMMC

[David Müller (ELSOFT AG) <d.mueller@xxxxxxxxx>]

Hi Jean-Michel

Jean-Michel Hautbois wrote:
> Can you show your DT (at least pinmux part and usdhc3 node) ?

	pinctrl_usdhc3: usdhc3grp {
		fsl,pins = <
			MX6QDL_PAD_SD3_CMD__SD3_CMD    0x1b0b1
			MX6QDL_PAD_SD3_CLK__SD3_CLK    0x100b1
			MX6QDL_PAD_SD3_DAT0__SD3_DATA0 0x1b0b1
			MX6QDL_PAD_SD3_DAT1__SD3_DATA1 0x1b0b1
			MX6QDL_PAD_SD3_DAT2__SD3_DATA2 0x1b0b1
			MX6QDL_PAD_SD3_DAT3__SD3_DATA3 0x1b0b1
			MX6QDL_PAD_SD3_DAT4__SD3_DATA4 0x1b0b1
			MX6QDL_PAD_SD3_DAT5__SD3_DATA5 0x1b0b1
			MX6QDL_PAD_SD3_DAT6__SD3_DATA6 0x1b0b1
			MX6QDL_PAD_SD3_DAT7__SD3_DATA7 0x1b0b1
			MX6QDL_PAD_SD3_RST__SD3_RESET  0x1b070
		>;
	};

&usdhc3 { /* eMMC */
	pinctrl-names = "default";
	pinctrl-0 = <&pinctrl_usdhc3>;
	vmmc-supply = <&reg_3v15>;
	non-removable;
	no-1-8-v;
	bus-width = <8>;
	status = "okay";
};


I've tracked the problem down to the point were the MMC code tries to
switch the eMMC to 8bit bus width (mmc_select_bus_width()).

--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html