Hi,
Fabio Estevam wrote:
> Hi Dong,
>
> I have tested the following patch to add support for the emmc port on
> mx6qsabresd:
>
> --- a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
> +++ b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
> @@ -444,6 +444,21 @@
> MX6QDL_PAD_SD3_DAT7__SD3_DATA7 0x17059
> >;
> };
> +
> + pinctrl_usdhc4: usdhc4grp {
> + fsl,pins = <
> + MX6QDL_PAD_SD4_CMD__SD4_CMD 0x17059
> + MX6QDL_PAD_SD4_CLK__SD4_CLK 0x10059
> + MX6QDL_PAD_SD4_DAT0__SD4_DATA0 0x17059
> + MX6QDL_PAD_SD4_DAT1__SD4_DATA1 0x17059
> + MX6QDL_PAD_SD4_DAT2__SD4_DATA2 0x17059
> + MX6QDL_PAD_SD4_DAT3__SD4_DATA3 0x17059
> + MX6QDL_PAD_SD4_DAT4__SD4_DATA4 0x17059
> + MX6QDL_PAD_SD4_DAT5__SD4_DATA5 0x17059
> + MX6QDL_PAD_SD4_DAT6__SD4_DATA6 0x17059
> + MX6QDL_PAD_SD4_DAT7__SD4_DATA7 0x17059
[...]
>
> Is there any extra patch I need to apply? I am running linux-next 20140506.
>
I'm using the pad settings 0x070b1 for our i.MX6 module with eMMC.
At least you should probably drop the HYS setting (0x10000), since
according to my experience the SD interface works much better with
hysteresis disabled.
Lothar Waßmann
--
___________________________________________________________
Ka-Ro electronics GmbH | Pascalstraße 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
Geschäftsführer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996
www.karo-electronics.de | info@xxxxxxxxxxxxxxxxxxx
___________________________________________________________
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
