Hi,
Sorry for the delay, just noticed this one.
* Dmitry Lifshitz <lifshitz@xxxxxxxxxxxxxx> [140324 02:34]:
> Hi,
>
> I've tested the branch omap_hsmmc_sdio_irq_devm_cleanup on custom OMAP5
> based board.
> We have mwifiex connected to MMC3.
>
> I used two approaches:
>
> * Using dat1 line as GPIO with dynamic remuxing
> * Using separate GPIO connected to dat1 with static mux settings
>
> Both works just fine. Thanks Andreas for a great solution.
>
> I have just one issue - how to define GPIO IRQ using DT in OMAP5 case.
> As a temporary hack for testing I used a fixed GPIO number and gpio_to_irq()
> call in omap_hsmmc_configure_wake_irq().
>
> OMAP5 MMC3 has the following DT entry (omap5.dtsi):
>
> mmc3: mmc@480ad000 {
> compatible = "ti,omap4-hsmmc";
> reg = <0x480ad000 0x400>;
> interrupts = <GIC_SPI 94 IRQ_TYPE_LEVEL_HIGH>;
> ti,hwmods = "mmc3";
> ti,needs-special-reset;
> dmas = <&sdma 77>, <&sdma 78>;
> dma-names = "tx", "rx";
> };
>
> What should be by board MMC3 setup?
You need to use the interrupts-extended property in omap5.dtsi
for the MMC interrupt. And if using the wake-up interrupts
for your board, you need to sepcify interrupts-extended in your
board file again to add the second wake-up interrupt.
If using the async wake-up path, the wake-up interrupt is the
OMAP5_CORE_IOPAD() or OMAP5_WKUP_IOPAD() pinctrl register offset
for that pin. If remuxing to GPIO for the wake-up, the wake-up
interrupt is the standard gpio interrupt property.
Then you also need this patch to avoid warnings during boot:
http://lkml.org/lkml/2014/4/10/620
After the above gets merged, we can apply the serial wake-up
patch too:
http://lists.infradead.org/pipermail/linux-arm-kernel/2013-November/213873.html
That shows you some examples on how to specify the wake-up
interrupt.
Regards,
Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
