Re: [PATCH 0/6] mmc: sdhci-s3c: Fix base clock source management

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 20.02.2014 20:26, Tomasz Figa wrote:
Hi Chris,

On 07.02.2014 10:58, Tomasz Figa wrote:
Hi Chris,

On 11.01.2014 22:39, Tomasz Figa wrote:
On platforms prior to Exynos the SDHCI block used internal clock
divider controlled by SELFREQ field of CLKCON register to divide base
clock selected from several external clocks fed to the block by
SELBASECLK bitfield of CONTROL2 register. Depending on wanted clock
frequency, different external clock may be the best choice and so
the driver needs to switch the SELBASECLK mux on the fly.

However the selection logic has been broken for quite some time leaving
the controller using always clock 0, which is not always the right
source and leading to suboptimal performance of the SDHCI block on
affected platforms.

This series intends to fix the problems mentioned above and also
clean-up
clock management code slightly.

Tested on S3C6410-based Mini6410 board, with following performance
figures:

* Before this series (133 MHz HCLK always selected, leading to at most
   33 MHz card clock):

root@tiny6410:~# hdparm -t /dev/mmcblk0

/dev/mmcblk0:
  Timing buffered disk reads:  42 MB in  3.10 seconds =  13.54 MB/sec
root@tiny6410:~# hdparm -t /dev/mmcblk0

/dev/mmcblk0:
  Timing buffered disk reads:  44 MB in  3.11 seconds =  14.14 MB/sec
root@tiny6410:~#

* After this series (48 MHz EPLL clock selected, leading to 48 MHz card
   clock):

root@tiny6410:~# hdparm -t /dev/mmcblk0

/dev/mmcblk0:
  Timing buffered disk reads:  56 MB in  3.04 seconds =  18.41 MB/sec
root@tiny6410:~# hdparm -t /dev/mmcblk0

/dev/mmcblk0:
  Timing buffered disk reads:  60 MB in  3.06 seconds =  19.63 MB/sec
root@tiny6410:~#

Tomasz Figa (6):
   mmc: sdhci-s3c: Use shifts to divide by powers of two
   mmc: sdhci-s3c: Cache bus clock rates
   mmc: sdhci-s3c: Use correct condition to check for clock presence
   mmc: sdhci-s3c: Simplify min/max clock calculation
   mmc: sdhci-s3c: Fix handling of bus clock switching
   mmc: sdhci-s3c: Do not allow frequencies higher than requested

  drivers/mmc/host/sdhci-s3c.c | 170
++++++++++++++++++++-----------------------
  1 file changed, 77 insertions(+), 93 deletions(-)


What do you think about this series?

Could you take this series for 3.15?

Ping.

It's been almost two months since I posted this series, it's been already ACKed and it would be nice to have it applied for upcoming release.

Best regards,
Tomasz
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux