On 02/06/2014 08:23 PM, Seungwon Jeon wrote:
> On Monday, February 03, 2014, Jaehoon Chung wrote:
>> Since using the device-tree, didn't use the callback pointer.
>> So removed the unused callback pointer.
>>
>>
> Above unnecessary line?
Remove it.
>
> Looks good to me.
> But just one thing is...
> We may need to consider alternative for setpower soon.
If we need to consider it, the related code should be located into SoC driver's file
Best Regards,
Jaehoon Chung
>
> Thanks,
> Seungwon Jeon
>
>> Signed-off-by: Jaehoon Chung <jh80.chung@xxxxxxxxxxx>
>> ---
>> Changelog V3:
>> - None
>> Changelog V2:
>> - None
>>
>> drivers/mmc/host/dw_mmc.c | 33 +++------------------------------
>> include/linux/mmc/dw_mmc.h | 14 --------------
>> 2 files changed, 3 insertions(+), 44 deletions(-)
>>
>> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
>> index e7357b8..551dade 100644
>> --- a/drivers/mmc/host/dw_mmc.c
>> +++ b/drivers/mmc/host/dw_mmc.c
>> @@ -850,8 +850,6 @@ static void __dw_mci_start_request(struct dw_mci *host,
>> u32 cmdflags;
>>
>> mrq = slot->mrq;
>> - if (host->pdata->select_slot)
>> - host->pdata->select_slot(slot->id);
>>
>> host->cur_slot = slot;
>> host->mrq = mrq;
>> @@ -985,17 +983,11 @@ static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
>> switch (ios->power_mode) {
>> case MMC_POWER_UP:
>> set_bit(DW_MMC_CARD_NEED_INIT, &slot->flags);
>> - /* Power up slot */
>> - if (slot->host->pdata->setpower)
>> - slot->host->pdata->setpower(slot->id, mmc->ocr_avail);
>> regs = mci_readl(slot->host, PWREN);
>> regs |= (1 << slot->id);
>> mci_writel(slot->host, PWREN, regs);
>> break;
>> case MMC_POWER_OFF:
>> - /* Power down slot */
>> - if (slot->host->pdata->setpower)
>> - slot->host->pdata->setpower(slot->id, 0);
>> regs = mci_readl(slot->host, PWREN);
>> regs &= ~(1 << slot->id);
>> mci_writel(slot->host, PWREN, regs);
>> @@ -1009,13 +1001,10 @@ static int dw_mci_get_ro(struct mmc_host *mmc)
>> {
>> int read_only;
>> struct dw_mci_slot *slot = mmc_priv(mmc);
>> - struct dw_mci_board *brd = slot->host->pdata;
>>
>> /* Use platform get_ro function, else try on board write protect */
>> if (slot->quirks & DW_MCI_SLOT_QUIRK_NO_WRITE_PROTECT)
>> read_only = 0;
>> - else if (brd->get_ro)
>> - read_only = brd->get_ro(slot->id);
>> else if (gpio_is_valid(slot->wp_gpio))
>> read_only = gpio_get_value(slot->wp_gpio);
>> else
>> @@ -1039,8 +1028,6 @@ static int dw_mci_get_cd(struct mmc_host *mmc)
>> /* Use platform get_cd function, else try onboard card detect */
>> if (brd->quirks & DW_MCI_QUIRK_BROKEN_CARD_DETECTION)
>> present = 1;
>> - else if (brd->get_cd)
>> - present = !brd->get_cd(slot->id);
>> else if (!IS_ERR_VALUE(gpio_cd))
>> present = gpio_cd;
>> else
>> @@ -2138,17 +2125,7 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id)
>> mmc->f_max = freq[1];
>> }
>>
>> - if (host->pdata->get_ocr)
>> - mmc->ocr_avail = host->pdata->get_ocr(id);
>> - else
>> - mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34;
>> -
>> - /*
>> - * Start with slot power disabled, it will be enabled when a card
>> - * is detected.
>> - */
>> - if (host->pdata->setpower)
>> - host->pdata->setpower(id, 0);
>> + mmc->ocr_avail = MMC_VDD_32_33 | MMC_VDD_33_34;
>>
>> if (host->pdata->caps)
>> mmc->caps = host->pdata->caps;
>> @@ -2217,10 +2194,6 @@ err_setup_bus:
>>
>> static void dw_mci_cleanup_slot(struct dw_mci_slot *slot, unsigned int id)
>> {
>> - /* Shutdown detect IRQ */
>> - if (slot->host->pdata->exit)
>> - slot->host->pdata->exit(id);
>> -
>> /* Debugfs stuff is cleaned up by mmc core */
>> mmc_remove_host(slot->mmc);
>> slot->host->slot[id] = NULL;
>> @@ -2395,9 +2368,9 @@ int dw_mci_probe(struct dw_mci *host)
>> }
>> }
>>
>> - if (!host->pdata->select_slot && host->pdata->num_slots > 1) {
>> + if (host->pdata->num_slots > 1) {
>> dev_err(host->dev,
>> - "Platform data must supply select_slot function\n");
>> + "Platform data must supply num_slots.\n");
>> return -ENODEV;
>> }
>>
>> diff --git a/include/linux/mmc/dw_mmc.h b/include/linux/mmc/dw_mmc.h
>> index 6ce7d2c..babaea9 100644
>> --- a/include/linux/mmc/dw_mmc.h
>> +++ b/include/linux/mmc/dw_mmc.h
>> @@ -248,20 +248,6 @@ struct dw_mci_board {
>> /* delay in mS before detecting cards after interrupt */
>> u32 detect_delay_ms;
>>
>> - int (*init)(u32 slot_id, irq_handler_t , void *);
>> - int (*get_ro)(u32 slot_id);
>> - int (*get_cd)(u32 slot_id);
>> - int (*get_ocr)(u32 slot_id);
>> - int (*get_bus_wd)(u32 slot_id);
>> - /*
>> - * Enable power to selected slot and set voltage to desired level.
>> - * Voltage levels are specified using MMC_VDD_xxx defines defined
>> - * in linux/mmc/host.h file.
>> - */
>> - void (*setpower)(u32 slot_id, u32 volt);
>> - void (*exit)(u32 slot_id);
>> - void (*select_slot)(u32 slot_id);
>> -
>> struct dw_mci_dma_ops *dma_ops;
>> struct dma_pdata *data;
>> struct block_settings *blk_settings;
>> --
>> 1.7.9.5
>> --
>> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
>> the body of a message to majordomo@xxxxxxxxxxxxxxx
>> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
