On Friday 20 December 2013 11:45 PM, Michael Trimarchi wrote:
Hi On Fri, Dec 20, 2013 at 6:35 PM, Balaji T K <balajitk@xxxxxx> wrote:In DT case, PBAIS registers are programmed via regulator, use regulator APIs to control PBIAS. Signed-off-by: Balaji T K <balajitk@xxxxxx> --- drivers/mmc/host/omap_hsmmc.c | 39 +++++++++++++++++++++++++++++++++++++++ 1 files changed, 39 insertions(+), 0 deletions(-) diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c index 342be25..0a390f8 100644 --- a/drivers/mmc/host/omap_hsmmc.c +++ b/drivers/mmc/host/omap_hsmmc.c @@ -126,6 +126,10 @@ #define OMAP_MMC_MAX_CLOCK 52000000 #define DRIVER_NAME "omap_hsmmc" +#define VDD_1V8 1800000 /* 180000 uV */ +#define VDD_3V0 3000000 /* 300000 uV */ +#define VDD_165_195 (ffs(MMC_VDD_165_195) - 1) + /* * One controller can have multiple slots, like on some omap boards using * omap.c controller driver. Luckily this is not currently done on any known @@ -164,6 +168,8 @@ struct omap_hsmmc_host { */ struct regulator *vcc; struct regulator *vcc_aux; + struct regulator *pbias; + bool pbias_enabled; int pbias_disable; void __iomem *base; resource_size_t mapbase; @@ -272,6 +278,15 @@ static int omap_hsmmc_set_power(struct device *dev, int slot, int power_on, if (mmc_slot(host).before_set_reg) mmc_slot(host).before_set_reg(dev, slot, power_on, vdd); + if (host->pbias) { + if (host->pbias_enabled == 1) { + ret = regulator_disable(host->pbias); + if (!ret) + host->pbias_enabled = 0;you should return error?+ } + regulator_set_voltage(host->pbias, VDD_3V0, VDD_3V0); + } + /* * Assume Vcc regulator is used only to power the card ... OMAP * VDDS is used to power the pins, optionally with a transceiver to @@ -306,9 +321,29 @@ static int omap_hsmmc_set_power(struct device *dev, int slot, int power_on, } } + if (host->pbias) { + if (vdd <= VDD_165_195) + ret = regulator_set_voltage(host->pbias, VDD_1V8, + VDD_1V8); + else + ret = regulator_set_voltage(host->pbias, VDD_3V0, + VDD_3V0); + if (ret < 0) + goto error_set_power; + + if (host->pbias_enabled == 0) { + ret = regulator_enable(host->pbias); + if (!ret) { + host->pbias_enabled = 1; + goto error_set_power;Is this an error condition? Do you need this flag?
Hi, pbias_enabled flag is used to balance regulator_enable/regulator_disable, otherwise regulator might be kept enabled base on to use count. -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
