On Wed, Dec 18, 2013 at 1:27 AM, Stephen Warren <swarren@xxxxxxxxxxxxx> wrote: > On 12/17/2013 02:25 AM, Dong Aisheng wrote: >> Hi Stephen, >> >> On Sat, Dec 14, 2013 at 6:43 AM, Stephen Warren <swarren@xxxxxxxxxxxxx> wrote: >>> On one of my eMMC devices, I see the following results from calling >>> mmc_do_calc_max_discard() with various parameters: >>> >>> [ 3.057263] MMC_DISCARD_ARG max_discard 1 >>> [ 3.057266] MMC_ERASE_ARG max_discard 4096 >>> [ 3.057267] MMC_TRIM_ARG max_discard 1 >>> >>> This causes mmc_calc_max_discard() to return 1, which makes the discard >>> IOCTL extremely slow. >>> >> >> IMX met the similar issue. >> http://www.spinics.net/lists/linux-mmc/msg23375.html >> It's caused by the max_discard_to supported by host is too small. >> >> I submitted the fix patches: >> http://www.spinics.net/lists/arm-kernel/msg294924.html >> Please see if it helps for you, especially patch #5. >> It could increase the max_discard_to if Tegra has same problem. > > Thanks for the pointer! > > Yes, Tegra has SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK set, and has a max > clock of 208MHz specified in HW, yet we only run the HW at 48MHz > upstream, since we haven't actually implemented any of the > advanced/faster transfer rates yet. Hence that patch does avoid/solve > the issue on 2 of my boards. > > However, the patch doesn't solve the problem on 2 other boards, since > the eMMC device on those boards specifies a much larger timeout, which > still causes max_discard to be set to 0. It sounds like the real > solution is what was discussed elsewhere in this thread; to use command > polling for erases? > > Even on the boards where your patch solves the problem, isn't it just a > temporary measure; as soon as we upstream the changes to enable the > faster transfer modes, we'll have a faster SDCLK, and hence again be > limited in the discard size, perhaps down to a single sector again. > Actually my patch is intend to fix 1) IMX incorrect max timeout issue 2) should not use max_clock to calculate max_discard_to issue for using SDCLK as timeout clock. The issue discussed here is a different issue that the card timeout may still be bigger than the host capability and how to use discard for such case. So your problem may exist if you meet some more big timeout cards. For IMX, when running at 50Mhz, the max timeout is more than 5s. It looks bigger enough currently and i tested many eMMC cards(Samsung, Toshiba, Sandisk, Hynix) and all they worked well with discard after fix. I don't know which eMMC cards you meet the issue and don't know what is Tegra max timeout. Just for SD3.0 cards working on 200Mhz, i observed one Toshiba SDHC U1 card could not do discard, since its AU erase timeout is 2s+ which exceeds the host capability 1335ms. Thus discard is automatically disabled. But another Sandisk SDXC can still work well since it has small ERASE_OFFSET as 1s. Regards Dong Aisheng > (Incidentally, I think the code should be limiting to a single erase > block, not a single sector. I'll send a separate patch to fix that, and > Cc everyone here). -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
