On Mon, December 16, 2013, Zhangfei Gao wrote:
> Dear Seungwon
>
> On 12/16/2013 11:50 AM, Seungwon Jeon wrote:
> > On Sat, December 14, 2013, Zhangfei Gao wrote:
>
> >> + /* SoC portion */
> >> + dwmmc_0: dwmmc0@fcd03000 {
> >> + compatible = "hisilicon,hi4511-dw-mshc";
> >> + reg = <0xfcd03000 0x1000>;
> >> + interrupts = <0 16 4>;
> >> + #address-cells = <1>;
> >> + #size-cells = <0>;
> >> + clocks = <&mmc_clock HI3620_SD_CIUCLK>, <&clock HI3620_DDRC_PER_CLK>;
> >> + clock-names = "ciu", "biu";
> >> + clock-freq-table =
> >> + <25000000 0 50000000 25000000 50000000 100000000 0 50000000>;
> > I think it could be solved with mmc->f_min and mmc->f_max(from clock-freq-min-max property)
> > if there is no limitation per each speed mode. As seeing described table, it looks that.
>
> Have tried them before, but unfortunately, they are different.
>
> The controller can not generate clock itself, while depending on the
> outside clock generator, which may require to change clock source in
> differnt mode.
>
> The value we want is set the capacibility of the clock input and the max
> clock freq where mmc works stable in that mode, which may be different
> in different mode.
>
> clock-freq-min-max will set the value for set_ios.
> For example, we use 25M as clock capability when init, which can not be
> set as freq-min, and used as set_ios, where 400K should be used,
> otherwise init definitely fail.
Can you check 'f_init' within 'drivers/mmc/core/core.c' file?
If you set 'f_min = 25000000' for init-sequence, mmc_set_ios() will pass that rate through 'ios.clock'
Then, dw_mmc-k3 can do clk_set_rate() with 25MHz at dw_mci_k3_set_ios().
And other required speeds for each mode seem not specific compared with standard spec.
Also clk_set_rate() would be possible with 'ios.clock' instead of specific table.
I just referred your example's clock-freq-table above.
>
> >> +static int dw_mci_k3_suspend(struct device *dev)
> >> +{
> >> + struct dw_mci *host = dev_get_drvdata(dev);
> >> +
> >> + if (!IS_ERR(host->ciu_clk))
> >> + clk_disable_unprepare(host->ciu_clk);
> >> +
> >> + return dw_mci_suspend(host);
> > If k3 needs clk_disable here, dw_mci_suspend()is expected to be called prior to
> clk_disable_unprepare()?
> > Of course, it's ok at present though.
> >
>
> Sure, it can be switched, though dw_mci_suspend does nothing related
> with clock now.
Yes, but if some works with ciu_clk is added in dw_mci_suspend(), it will affect.
Thanks,
Seungwon Jeon
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
