On 12/13/2013 04:40 AM, Arnd Bergmann wrote:
On Thursday 12 December 2013, zhangfei wrote:
On 12/12/2013 04:12 AM, Arnd Bergmann wrote:
On Wednesday 11 December 2013, zhangfei wrote:
But aren't the times fixed for each mode? Why do you need to specify them in
the DT? I would expect that the clock rates for each mode are set in the
MMC and SD specifications. When you call clk_set_rate(), it should normally
be enough to ask for the clock you actually want and let the clk subsystem
figure out how to set up the parents and multipliers on the way.
Yes. that's will be perfect.
However, currently this ip still has no such capability.
Input rate for init are diferent for different controller, not the
init 400K, some are 13M, others are 25M, since different clock source.
This can be easily solved by clock-freq-init = <25000000>
2. There is maxmum limit, also can be easily solved by define CLK_MAX.
3. However some mode can not use the max speed from ios->clock
for example UHS_SDR104_MAX_DTR 208000000 can not be used, only half may
be reached, at least currently.
I don't fully understand the explanation,
This is the ip's limitation currently, that some mode can only operate
at limited freq, rather than the max freq from spec.
Will upgrade to use ios->clock once the limitation is solved.
but if some of the other
people with interest in dw-mmc (I've added some more to Cc now) think
this makes sense, I'm fine with it too.
Could I treat this as Ack or Partially Ack for the next version :)
How about this desc
* clock-freq-table: should be the frequency (in Hz) array of the ciu
clock
in each supported timing.
1. CIU clock rate in HZ for MMC_TIMING_LEGACY mode
2. CIU clock rate in HZ for MMC_TIMING_MMC_HS mode
3. CIU clock rate in HZ for MMC_TIMING_SD_HS mode
4. CIU clock rate in HZ for MMC_TIMING_UHS_SDR12 mode
5. CIU clock rate in HZ for MMC_TIMING_UHS_SDR25 mode
6. CIU clock rate in HZ for MMC_TIMING_UHS_SDR50 mode
7. CIU clock rate in HZ for MMC_TIMING_UHS_SDR104 mode
8. CIU clock rate in HZ for MMC_TIMING_SD_HS mode
9. CIU clock rate in HZ for MMC_TIMING_MMC_HS200 mode
Yes, that is much better. but please avoid using Linux internal
identifiers (e.g. MMC_TIMING_LEGACY) and instead use the terminology from
the MMC and SD specs. Also 'Hz' is the official symbol for Hertz, not 'HZ'.
Update to
* clock-freq-table: should be the frequency (in Hz) array of the ciu clock
in each supported mode.
0. CIU clock rate in Hz for DS mode
1. CIU clock rate in Hz for MMC HS mode
2. CIU clock rate in Hz for SD HS mode
3. CIU clock rate in Hz for SDR12 mode
4. CIU clock rate in Hz for SDR25 mode
5. CIU clock rate in Hz for SDR50 mode
6. CIU clock rate in Hz for SDR104 mode
7. CIU clock rate in Hz for DDR50 mode
8. CIU clock rate in Hz for HS200 mode
Thanks
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
