* Tony Lindgren <tony@xxxxxxxxxxx> [131210 10:34]:
> * Balaji T K <balajitk@xxxxxx> [131210 06:36]:
> > pbias register controls internal power supply to sd card i/o pads
> > in most OMAPs (OMAP2-5, DRA7).
> > Control bits for selecting voltage level and
> > enabling/disabling are in the same PBIAS register.
>
> Good to see this, few comments below.
>
> > +++ lo/Documentation/devicetree/bindings/regulator/pbias-regulator.txt 2013-12-10 16:58:28.907927745 +0530
> > @@ -0,0 +1,21 @@
> > +PBIAS internal regulator for SD card i/o pads on OMAP SoCs.
> > +
> > +Required properties:
> > +- compatible:
> > + - "regulator-pbias-omap2" for OMAP2
> > + - "regulator-pbias-omap3" for OMAP3
> > + - "regulator-pbias-omap4" for OMAP4
> > + - "regulator-pbias-omap5" for OMAP5, DRA7
> > +- pbias-reg-offset: PBIAS control register offset from syscon base address
> > +
> > +Optional properties:
> > +- Any optional property defined in bindings/regulator/regulator.txt
> > +
> > +Example:
> > +
> > + pbias_regulator: pbias_regulator {
Hmm one more comment. This should containe the standard property:
reg = <0x02b0 0x4>;
And the parent SCM driver should claim the whole SCM GENERAL register
area as defined in "Table 13-68. GENERAL Register Summary" for omap3
for example. So that would be the following for the parent:
reg = <0x48002270 xxx>;
The size needs to be checked and it may need multiple regions or instances
defined. That way we can use the drivers/mfd/syscon.c SCM driver for all
the misc registers without having to redo the bindings.
Regards,
Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
