The MMC subsystem handles looking for a card at probe time. Queuing up our own can race with the rest of the MMC subsystem and cause problems if we get unlucky with timing. Just remove our own detection. Specifically, I found that with just the right set of printouts in my system that one of the three SD/MMC devices in my system was having trouble probing. It would get an err -123 (-ENOMEDIUM) during probe. I found that the source of the error was in dw_mci_work_routine_card(). Adding more printouts to the code sometimes made this error go away, so it's a little touchy. You can see a snippet with my printouts in it (printouts were in set_ios() on an exynos5420 board with some of our local patches): [ 4.216595] dwmmc_exynos 12210000.dwmmc1: Using internal DMA controller. [ 4.395935] dwmmc_exynos 12210000.dwmmc1: Version ID is 250a [ 4.401948] dwmmc_exynos 12210000.dwmmc1: DW MMC controller at irq 108, 64 bit host data width, 64 deep fifo [ 4.424430] dwmmc_exynos 12210000.dwmmc1: sdr0 mode (irq=108, width=0) [ 4.453975] dwmmc_exynos 12210000.dwmmc1: sdr0 mode (irq=108, width=0) [ 4.459592] mmc_host mmc1: Bus speed (slot 0) = 100000000Hz (slot req 400000Hz, actual 400000HZ div = 125) [ 4.484258] dwmmc_exynos 12210000.dwmmc1: 1 slots initialized [ 4.485406] dwmmc_exynos 12210000.dwmmc1: sdr0 mode (irq=108, width=0) [ 4.487606] dwmmc_exynos 12210000.dwmmc1: sdr0 mode (irq=108, width=0) [ 4.489794] dwmmc_exynos 12210000.dwmmc1: sdr0 mode (irq=108, width=0) [ 4.509757] mmc1: error -123 whilst initialising SDIO card While digging I found that doing our own card detection at init time didn't appear to be necessary. If I remove this code then cards that are in the system at bootup are still detected just fine. Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx> --- drivers/mmc/host/dw_mmc.c | 6 ------ 1 file changed, 6 deletions(-) diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c index bc3a1bc..c3a6fe9 100644 --- a/drivers/mmc/host/dw_mmc.c +++ b/drivers/mmc/host/dw_mmc.c @@ -2016,12 +2016,6 @@ static int dw_mci_init_slot(struct dw_mci *host, unsigned int id) /* Card initially undetected */ slot->last_detect_state = 0; - /* - * Card may have been plugged in prior to boot so we - * need to run the detect tasklet - */ - queue_work(host->card_workqueue, &host->card_work); - return 0; err_setup_bus: -- 1.8.3 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
