From: Kevin Liu <kliu5@xxxxxxxxxxx>
Mmc does NOT have special sequence requirements for 1.8v
signal voltage setting compared to sd and sdio.
Add a new 1.8v flag for mmc so as to use the same
start_signal_voltage_switch interface.
Signed-off-by: Kevin Liu <kliu5@xxxxxxxxxxx>
---
drivers/mmc/core/mmc.c | 3 ++-
include/linux/mmc/host.h | 1 +
2 files changed, 3 insertions(+), 1 deletions(-)
diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index 7509de1..3aa7f14 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -758,7 +758,8 @@ static int mmc_select_hs200(struct mmc_card *card)
if (err && card->ext_csd.card_type & EXT_CSD_CARD_TYPE_SDR_1_8V &&
host->caps2 & MMC_CAP2_HS200_1_8V_SDR)
- err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180, 0);
+ err = mmc_set_signal_voltage(host,
+ MMC_SIGNAL_VOLTAGE_MMC_180, 0);
/* If fails try again during next card power cycle */
if (err)
diff --git a/include/linux/mmc/host.h b/include/linux/mmc/host.h
index 0ee92d2..d9ab286 100644
--- a/include/linux/mmc/host.h
+++ b/include/linux/mmc/host.h
@@ -71,6 +71,7 @@ struct mmc_ios {
#define MMC_SIGNAL_VOLTAGE_330 0
#define MMC_SIGNAL_VOLTAGE_180 1
#define MMC_SIGNAL_VOLTAGE_120 2
+#define MMC_SIGNAL_VOLTAGE_MMC_180 3
unsigned char drv_type; /* driver type (A, B, C, D) */
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
