Hi Girish,
Well..just tested on my board.
this patch didn't work.(eMMC card didn't initialize)
meaning of ios->bus_mode and synosys's bus_mode is same?
How did you test this patch?
Best Regards,
Jaehoon Chung
On 07/23/2012 08:16 PM, Girish K S wrote:
> Synopsis Designware host controller has suppport for open
> drain mode selection. During the mmc card initialization the
> host controller can select the open-drain bit to allow the device
> initialization in the open-drain mode. Once the device enters
> the standby mode this bit can be reset to enter push-pull mode.
>
> Signed-off-by: Girish K S <girish.shivananjappa@xxxxxxxxxx>
> ---
> drivers/mmc/host/dw_mmc.c | 14 ++++++++++++++
> drivers/mmc/host/dw_mmc.h | 1 +
> 2 files changed, 15 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
> index 72dc3cd..da11e5a 100644
> --- a/drivers/mmc/host/dw_mmc.c
> +++ b/drivers/mmc/host/dw_mmc.c
> @@ -773,6 +773,18 @@ static void dw_mci_request(struct mmc_host *mmc, struct mmc_request *mrq)
> spin_unlock_bh(&host->lock);
> }
>
> +static void dw_mci_set_busmode(struct dw_mci_slot *slot)
> +{
> + struct mmc_ios *ios = &slot->mmc->ios;
> + u32 reg;
> +
> + reg = mci_readl(slot->host, CTRL);
> + if (ios->bus_mode == MMC_BUSMODE_OPENDRAIN)
> + mci_writel(slot->host, CTRL, reg | SDMMC_CTRL_ENABLE_OD);
> + else
> + mci_writel(slot->host, CTRL, reg & ~SDMMC_CTRL_ENABLE_OD);
> +}
> +
> static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
> {
> struct dw_mci_slot *slot = mmc_priv(mmc);
> @@ -818,6 +830,8 @@ static void dw_mci_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
> default:
> break;
> }
> +
> + dw_mci_set_busmode(slot);
> }
>
> static int dw_mci_get_ro(struct mmc_host *mmc)
> diff --git a/drivers/mmc/host/dw_mmc.h b/drivers/mmc/host/dw_mmc.h
> index 15c27e1..1a53fb2 100644
> --- a/drivers/mmc/host/dw_mmc.h
> +++ b/drivers/mmc/host/dw_mmc.h
> @@ -67,6 +67,7 @@
>
> /* Control register defines */
> #define SDMMC_CTRL_USE_IDMAC BIT(25)
> +#define SDMMC_CTRL_ENABLE_OD BIT(24)
> #define SDMMC_CTRL_CEATA_INT_EN BIT(11)
> #define SDMMC_CTRL_SEND_AS_CCSD BIT(10)
> #define SDMMC_CTRL_SEND_CCSD BIT(9)
>
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
