Currently only 1.2V is treated for HS200 mode. If the host has
only 1.8V I/O capability not 1.2V, mmc_set_signal_voltage can't
be called for 1.8V HS200. EXT_CSD_CARD_TYPE_SDR_1_8V needs to be
considered.
Signed-off-by: Seungwon Jeon <tgih.jun@xxxxxxxxxxx>
---
drivers/mmc/core/mmc.c | 12 +++++++-----
1 files changed, 7 insertions(+), 5 deletions(-)
diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index 0477769..2a9b7b1 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -728,7 +728,7 @@ static int mmc_select_powerclass(struct mmc_card *card,
*/
static int mmc_select_hs200(struct mmc_card *card)
{
- int idx, err = 0;
+ int idx, err = -EINVAL;
struct mmc_host *host;
static unsigned ext_csd_bits[] = {
EXT_CSD_BUS_WIDTH_4,
@@ -744,10 +744,12 @@ static int mmc_select_hs200(struct mmc_card *card)
host = card->host;
if (card->ext_csd.card_type & EXT_CSD_CARD_TYPE_SDR_1_2V &&
- host->caps2 & MMC_CAP2_HS200_1_2V_SDR)
- if (mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120, 0))
- err = mmc_set_signal_voltage(host,
- MMC_SIGNAL_VOLTAGE_180, 0);
+ host->caps2 & MMC_CAP2_HS200_1_2V_SDR)
+ err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_120, 0);
+
+ if (err && card->ext_csd.card_type & EXT_CSD_CARD_TYPE_SDR_1_8V &&
+ host->caps2 & MMC_CAP2_HS200_1_8V_SDR)
+ err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180, 0);
/* If fails try again during next card power cycle */
if (err)
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
