The driver should not try to switch to 1.8V when the SD 3.0 host controller does not have any UHS capabilities bits set (SDR50, DDR50 or SDR104). See page 72 of "SD Specifications Part A2 SD Host Controller Simplified Specification Version 3.00" under "1.8V Signaling Enable". Instead of setting SDR12 and SDR25 in the host capabilities data structure for all V3.0 host controllers, only set them if SDR104, SDR50 or DDR50 is set in the host capabilities register. This will prevent the switch to 1.8V later. Signed-off-by: Al Cooper <acooper@xxxxxxxxx> --- drivers/mmc/host/sdhci.c | 5 +++-- 1 files changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index 8d66706..cdf900e 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -2762,8 +2762,9 @@ int sdhci_add_host(struct sdhci_host *host) mmc_card_is_removable(mmc)) mmc->caps |= MMC_CAP_NEEDS_POLL; - /* UHS-I mode(s) supported by the host controller. */ - if (host->version >= SDHCI_SPEC_300) + /* Any UHS-I mode in caps implies SDR12 and SDR25 support. */ + if (caps[1] & (SDHCI_SUPPORT_SDR104 | SDHCI_SUPPORT_SDR50 | + SDHCI_SUPPORT_DDR50)) mmc->caps |= MMC_CAP_UHS_SDR12 | MMC_CAP_UHS_SDR25; /* SDR104 supports also implies SDR50 support */ -- 1.7.6 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
