Hi, I am using a Freescale iMX53 Quick Start Board. The uSD card that comes with the device contains a Linux kernel labeled "Linux version 2.6.35.3-01129-g691c08a-dirty". After some digging I found out that this corresponds to the "imx_2.6.35_11.09.01" tag in the Freescale Linux kernel that can be found at http://opensource.freescale.com/pub/scm/imx/linux-2.6-imx.git I am experimenting with an SDIO card and that one works fine using that kernel. So far, so good. Now I have tried to use a vanilla Git Linux kernel (3.3.0-rc6+) with mixed results. The card is recognised correctly and mostly initialised, up to the point where an apparently an interrupt from the card is expected to happen. Because the SDHCI driver supports "real" interrupts (via MMC_CAP_SDIO_IRQ) the SDIO IRQ thread goes to sleep, but is never woken up in my case. After about 2.5 seconds, I receive an error -110 (timeout) and the initialisation is aborted. So my question is: is anybody using an iMX53 (or any other hardware using the SDHCI driver) together with "real" interrupts (via MMC_CAP_SDIO_IRQ), not polled interrupts? The main problem is that the ancient Freescale 2.6.35 kernel is using the "mx_sdhci" driver, while in 3.3.0-rc6+ the generic "sdhci" driver is used, so it's not possible to simply compare the changes between the two versions. :-( Does anybody know the difference between the "mx_sdhci" from Freescale 2.6.35 kernel and the the "sdhci" driver in 3.3.0-rc6+? Probably this is a question for the Freescale people: why was the "mx_sdhci" necessary at all and why is it not necessary any more? Any help, hints and historical informations are highly appreciated, before I start to look deeper into this problem. CU Michael. -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
