Re: [PATCH v2 1/4] mmc: omap_hsmmc: Convert hsmmc driver to use device tree

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 23 Feb 2012 17:31:27 +0530, Rajendra Nayak <rnayak@xxxxxx> wrote:
> Define dt bindings for the ti-omap-hsmmc, and adapt
> the driver to extract data (which was earlier passed as
> platform_data) from device tree.
> 
> Signed-off-by: Rajendra Nayak <rnayak@xxxxxx>
> ---
>  .../devicetree/bindings/mmc/ti-omap-hsmmc.txt      |   31 +++++++++
>  drivers/mmc/host/omap_hsmmc.c                      |   68 ++++++++++++++++++++
>  2 files changed, 99 insertions(+), 0 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> 
> diff --git a/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> new file mode 100644
> index 0000000..e4fa8f0
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
> @@ -0,0 +1,31 @@
> +* TI Highspeed MMC host controller for OMAP
> +
> +The Highspeed MMC Host Controller on TI OMAP family
> +provides an interface for MMC, SD, and SDIO types of memory cards.
> +
> +Required properties:
> +- compatible:
> + Should be "ti,omap2-hsmmc", for OMAP2/3 controllers
> + Should be "ti,omap4-hsmmc", for OMAP4 controllers
> +- ti,hwmods: Must be "mmc<n>", n is controller instance starting 1
> +- reg : should contain hsmmc registers location and length
> +
> +Optional properties:
> +ti,dual-volt: boolean, supports dual voltage cards
> +<supply-name>-supply: phandle to the regulator device tree node
> +"supply-name" examples are "vmmc", "vmmc_aux" etc
> +ti,bus-width: Number of data lines, default assumed is 1 if the property is missing.
> +cd-gpios: GPIOs for card detection
> +wp-gpios: GPIOs for write protection
> +ti,non-removable: non-removable slot (like eMMC)

Binding looks okay.  A couple comments below...

[...]
> +static const struct of_device_id omap_mmc_of_match[];

If you move the omap_mmc_of_match[] table up to here then there is no
need for the forward declaration.

> +
>  static int __init omap_hsmmc_probe(struct platform_device *pdev)
>  {
>  	struct omap_mmc_platform_data *pdata = pdev->dev.platform_data;
> @@ -1725,6 +1768,14 @@ static int __init omap_hsmmc_probe(struct platform_device *pdev)
>  	struct omap_hsmmc_host *host = NULL;
>  	struct resource *res;
>  	int ret, irq;
> +	const struct of_device_id *match;
> +
> +	match = of_match_device(omap_mmc_of_match, &pdev->dev);
> +	if (match) {
> +		pdata = of_get_hsmmc_pdata(&pdev->dev);
> +		if (match->data)
> +			pdata->reg_offset = *(u16 *)match->data;

Blech on the ugly cast.  It is slightly safer to do thusly:

	u16 *offsetp = match->data;
	pdata->reg_offset = *offsetp

> +	}
>  
>  	if (pdata == NULL) {
>  		dev_err(&pdev->dev, "Platform Data is missing\n");
> @@ -2120,12 +2171,29 @@ static struct dev_pm_ops omap_hsmmc_dev_pm_ops = {
>  	.runtime_resume = omap_hsmmc_runtime_resume,
>  };
>  
> +#if defined(CONFIG_OF)
> +static u16 omap4_reg_offset = 0x100;
> +
> +static const struct of_device_id omap_mmc_of_match[] = {
> +	{
> +		.compatible = "ti,omap2-hsmmc",
> +	},
> +	{
> +		.compatible = "ti,omap4-hsmmc",
> +		.data = &omap4_reg_offset,
> +	},
> +	{},
> +}
> +MODULE_DEVICE_TABLE(of, omap_mmc_of_match);
> +#endif
> +
>  static struct platform_driver omap_hsmmc_driver = {
>  	.remove		= omap_hsmmc_remove,
>  	.driver		= {
>  		.name = DRIVER_NAME,
>  		.owner = THIS_MODULE,
>  		.pm = &omap_hsmmc_dev_pm_ops,
> +		.of_match_table = of_match_ptr(omap_mmc_of_match),
>  	},
>  };
>  
> -- 
> 1.7.1
> 
> 
> _______________________________________________
> linaro-dev mailing list
> linaro-dev@xxxxxxxxxxxxxxxx
> http://lists.linaro.org/mailman/listinfo/linaro-dev

-- 
Grant Likely, B.Sc, P.Eng.
Secret Lab Technologies,Ltd.
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux