Move the SDIO preparation to be done before the DMA job is setup. This makes it possible to do DMA for SDIO transfers as well as the earlier supported pio mode. Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxxxxxx> Signed-off-by: Stefan Nilsson XK <stefan.xk.nilsson@xxxxxxxxxxxxxx> --- drivers/mmc/host/mmci.c | 10 +++++----- 1 files changed, 5 insertions(+), 5 deletions(-) diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c index 50b5f99..1b73177 100644 --- a/drivers/mmc/host/mmci.c +++ b/drivers/mmc/host/mmci.c @@ -604,6 +604,11 @@ static void mmci_start_data(struct mmci_host *host, struct mmc_data *data) if (data->flags & MMC_DATA_READ) datactrl |= MCI_DPSM_DIRECTION; + /* The ST Micro variants has a special bit to enable SDIO */ + if (variant->sdio && host->mmc->card) + if (mmc_card_sdio(host->mmc->card)) + datactrl |= MCI_ST_DPSM_SDIOEN; + /* * Attempt to use DMA operation mode, if this * should fail, fall back to PIO mode @@ -632,11 +637,6 @@ static void mmci_start_data(struct mmci_host *host, struct mmc_data *data) irqmask = MCI_TXFIFOHALFEMPTYMASK; } - /* The ST Micro variants has a special bit to enable SDIO */ - if (variant->sdio && host->mmc->card) - if (mmc_card_sdio(host->mmc->card)) - datactrl |= MCI_ST_DPSM_SDIOEN; - writel(datactrl, base + MMCIDATACTRL); writel(readl(base + MMCIMASK0) & ~MCI_DATAENDMASK, base + MMCIMASK0); mmci_set_mask1(host, irqmask); -- 1.7.5.4 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
