Eric,
Not sure what to suggest.
If it makes more sense to take V3 which powers on the wifi card but does not do power handling per
new spec take that. At least wifi card works and then wait for power code. New code could delete
power code as part of the mod.
If it makes more sense to wait for power code -- take V4.
Philip
V4
==
remove code to enable power for wifi. Coming in separate patch
(by others) that conforms to new power architecture.
V3
==
Change since V2 -- delete mmc3 since it was committed
to linux next.
enable mmc1 used for wifi (8688) and marked PERMANENT.
Wifi requires enabling of power on the device by
toggling the gpio lines for power and reset.
Signed-off-by: Philip Rakity <prakity@xxxxxxxxxxx>
---
arch/arm/mach-mmp/brownstone.c | 8 +++++++-
1 files changed, 7 insertions(+), 1 deletions(-)
diff --git a/arch/arm/mach-mmp/brownstone.c b/arch/arm/mach-mmp/brownstone.c
index c79162a..7634b2f 100644
--- a/arch/arm/mach-mmp/brownstone.c
+++ b/arch/arm/mach-mmp/brownstone.c
@@ -180,6 +180,11 @@ static struct sdhci_pxa_platdata mmp2_sdh_platdata_mmc0 = {
.clk_delay_cycles = 0x1f,
};
+static struct sdhci_pxa_platdata mmp2_sdh_platdata_mmc1 = {
+ .clk_delay_cycles = 0x1f,
+ .flags = PXA_FLAG_CARD_PERMANENT,
+};
+
static struct sdhci_pxa_platdata mmp2_sdh_platdata_mmc2 = {
.clk_delay_cycles = 0x1f,
.flags = PXA_FLAG_CARD_PERMANENT
@@ -195,8 +200,9 @@ static void __init brownstone_init(void)
mmp2_add_uart(1);
mmp2_add_uart(3);
mmp2_add_twsi(1, NULL, ARRAY_AND_SIZE(brownstone_twsi1_info));
- mmp2_add_sdhost(0, &mmp2_sdh_platdata_mmc0); /* SD/MMC */
mmp2_add_sdhost(2, &mmp2_sdh_platdata_mmc2); /* eMMC */
+ mmp2_add_sdhost(0, &mmp2_sdh_platdata_mmc0); /* SD/MMC */
+ mmp2_add_sdhost(1, &mmp2_sdh_platdata_mmc1); /* Wifi */
/* enable 5v regulator */
platform_device_register(&brownstone_v_5vp_device);
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
