Hi all, in 3.0.0-rc1 (and if i remember correctly earlier in the merge window before the tag too) my built-in SD/MMC slot does not work as it did with 2.6.39. Any ideas/patches? Does it help to enable mmc-debugging? Regards, Oliver Linux version 2.6.39 Jun 5 13:40:28 mybox kernel: [ 6.209758] sdhci: Secure Digital Host Controller Interface driver Jun 5 13:40:28 mybox kernel: [ 6.209761] sdhci: Copyright(c) Pierre Ossman (..) Jun 5 13:40:28 mybox kernel: [ 6.366993] sdhci-pci 0000:03:00.1: SDHCI controller found [1180:e822] (rev 3) Jun 5 13:40:28 mybox kernel: [ 6.367017] sdhci-pci 0000:03:00.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19 Jun 5 13:40:28 mybox kernel: [ 6.367847] mmc0: SDHCI controller on PCI [0000:03:00.1] using DMA Linux version 3.0.0-rc1-00180-g0792644 (the very latest from Linus' linux-2.6 git tree) Jun 5 13:58:16 mybox kernel: [ 6.119533] sdhci: Secure Digital Host Controller Interface driver Jun 5 13:58:16 mybox kernel: [ 6.121400] sdhci: Copyright(c) Pierre Ossman (..) Jun 5 13:58:16 mybox kernel: [ 6.242510] sdhci-pci 0000:03:00.1: SDHCI controller found [1180:e822] (rev 3) Jun 5 13:58:16 mybox kernel: [ 6.244168] sdhci-pci 0000:03:00.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19 Jun 5 13:58:16 mybox kernel: [ 6.247609] sdhci-pci 0000:03:00.1: PCI INT B disabled dmesg is a bit more detailed: [ 6.242510] sdhci-pci 0000:03:00.1: SDHCI controller found [1180:e822] (rev 3) [ 6.244168] sdhci-pci 0000:03:00.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19 [ 6.245788] sdhci-pci 0000:03:00.1: BAR 0 is not iomem. Aborting. [ 6.247609] sdhci-pci 0000:03:00.1: PCI INT B disabled lspci says: 03:00.0 CardBus bridge: Ricoh Co Ltd Device e476 (rev 02) 03:00.1 SD Host controller: Ricoh Co Ltd MMC/SD Host Controller (rev 03) 03:00.4 FireWire (IEEE 1394): Ricoh Co Ltd FireWire Host Controller (rev 03) Used config: # # MMC/SD/SDIO Host Controller Drivers # CONFIG_MMC_SDHCI=m CONFIG_MMC_SDHCI_PCI=m # CONFIG_MMC_RICOH_MMC is not set <<-- was set in the 2.6.39 mmc config (see below) # CONFIG_MMC_SDHCI_PLTFM is not set # CONFIG_MMC_WBSD is not set # CONFIG_MMC_TIFM_SD is not set # CONFIG_MMC_SDRICOH_CS is not set # CONFIG_MMC_CB710 is not set # CONFIG_MMC_VIA_SDMMC is not set # CONFIG_MMC_VUB300 is not set <<-- the only difference to 2.6.39 mmc config # CONFIG_MMC_USHC is not set # CONFIG_MEMSTICK is not set CONFIG_NEW_LEDS=y CONFIG_LEDS_CLASS=y Enabling/disabling CONFIG_MMC_RICOH_MMC does not have any effect. -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
