The reason was that it takes time for controller to detect the card. So wait a bit for the card to appear. In worst case scenario, when you suspend the system with mmc card, and actually remove it, the resume will be delayed maximum by 2 seconds Signed-off-by: Maxim Levitsky <maximlevitsky@xxxxxxxxx> --- drivers/mmc/host/sdhci-pci.c | 3 ++- drivers/mmc/host/sdhci.c | 18 ++++++++++++++++++ drivers/mmc/host/sdhci.h | 2 ++ 3 files changed, 22 insertions(+), 1 deletions(-) diff --git a/drivers/mmc/host/sdhci-pci.c b/drivers/mmc/host/sdhci-pci.c index c4bcaeb..49d863c 100644 --- a/drivers/mmc/host/sdhci-pci.c +++ b/drivers/mmc/host/sdhci-pci.c @@ -115,7 +115,8 @@ static const struct sdhci_pci_fixes sdhci_ricoh_mmc = { .quirks = SDHCI_QUIRK_32BIT_DMA_ADDR | SDHCI_QUIRK_CLOCK_BEFORE_RESET | SDHCI_QUIRK_NO_CARD_NO_RESET | - SDHCI_QUIRK_MISSING_CAPS + SDHCI_QUIRK_MISSING_CAPS | + SDHCI_QUIRK_WAIT_CARD_ON_RESUME }; static const struct sdhci_pci_fixes sdhci_ene_712 = { diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index 483b78e..6cda505 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -1612,6 +1612,24 @@ int sdhci_resume_host(struct sdhci_host *host) { int ret; + /* Some controllers (especialy the ricoh mmc controller) delay + card detection on resume (probably since the controller + has to poke the card to determine if its MMC or not */ + + if (host->mmc->bus_ops && (host->quirks & + SDHCI_QUIRK_WAIT_CARD_ON_RESUME)) { + + unsigned long timeout = jiffies + msecs_to_jiffies(2000); + + while (!time_after(jiffies, timeout)) + if (sdhci_readl(host, SDHCI_PRESENT_STATE) + & SDHCI_CARD_PRESENT) { + break; + } + cpu_relax(); + } + + if (host->flags & (SDHCI_USE_SDMA | SDHCI_USE_ADMA)) { if (host->ops->enable_dma) host->ops->enable_dma(host); diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h index b1839a3..c9d099c 100644 --- a/drivers/mmc/host/sdhci.h +++ b/drivers/mmc/host/sdhci.h @@ -242,6 +242,8 @@ struct sdhci_host { #define SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC (1<<26) /* Controller is missing device caps. Use caps provided by host */ #define SDHCI_QUIRK_MISSING_CAPS (1<<27) +/* Card doesn't appear immediatly on resume from low power state */ +#define SDHCI_QUIRK_WAIT_CARD_ON_RESUME (1<<28) int irq; /* Device IRQ */ void __iomem * ioaddr; /* Mapped address */ -- 1.7.0.4 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html