Re: [PATCH] OMAP35xx:SDIO IRQ Support for OMAP35xx

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

Phaneendra Kumar Alapati wrote:
> This patch adds SDIO IRQ support for OMAP35xx. Tested on OMAP3530EVM
> with Marvell 88W8686 card and below are the observed throughput results
> (ttcp utility): 13Mbps (Downlink), 10.5 Mbps(Uplink)
>
> Signed-off-by: Phaneendra Kumar <phani@xxxxxxxxxxx>
> ---
>  drivers/mmc/host/omap_hsmmc.c |   55 ++++++++++++++++++++++++++++++++++++----
>  1 files changed, 49 insertions(+), 6 deletions(-)

I've tried the patch on CM-T35 that has Marvell 88W8686 on-board and
surprisingly I get a lot of command timeouts from the libertas driver :(
---
libertas: requeueing command 0x0006 due to timeout (#1)
libertas: Received result 0 to command 6 after 1 retries
libertas: command 0x0006 timed out
---
I hope I'll find time to debug it in the next few days and provide more valuable
information...


> diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
> index 4b23225..fa94580 100644
> --- a/drivers/mmc/host/omap_hsmmc.c
> +++ b/drivers/mmc/host/omap_hsmmc.c
> @@ -100,6 +100,10 @@
>  #define SRD			(1 << 26)
>  #define SOFTRESET		(1 << 1)
>  #define RESETDONE		(1 << 0)
> +#define CIRQ		(1 << 8)
> +#define CIRQ_ENABLE	(1 << 8)
> +#define CTPL		(1 << 11)
> +#define CLKEXTFREE	(1 << 16)
>  
>  /*
>   * FIXME: Most likely all the data using these _DEVID defines should come
> @@ -171,6 +175,7 @@ struct omap_hsmmc_host {
>  	int			vdd;
>  	int			protect_card;
>  	int			reqs_blocked;
> +	int			sdio_int;
>  
>  	struct	omap_mmc_platform_data	*pdata;
>  };
> @@ -436,6 +441,13 @@ omap_hsmmc_start_command(struct omap_hsmmc_host *host, struct mmc_command *cmd,
>  	else
>  		OMAP_HSMMC_WRITE(host->base, IE, INT_EN_MASK);
>  
> +	if (host->sdio_int) {
> +		OMAP_HSMMC_WRITE(host->base, ISE,
> +			(OMAP_HSMMC_READ(host->base, ISE) | CIRQ_ENABLE));
> +		OMAP_HSMMC_WRITE(host->base, IE,
> +			(OMAP_HSMMC_READ(host->base, IE) | CIRQ_ENABLE));
> +	}
> +
>  	host->response_busy = 0;
>  	if (cmd->flags & MMC_RSP_PRESENT) {
>  		if (cmd->flags & MMC_RSP_136)
> @@ -640,6 +652,17 @@ static irqreturn_t omap_hsmmc_irq(int irq, void *dev_id)
>  
>  	spin_lock(&host->irq_lock);
>  
> +	data = host->data;
> +	status = OMAP_HSMMC_READ(host->base, STAT);
> +	dev_dbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
> +
> +	if (host->mmc->caps & MMC_CAP_SDIO_IRQ) {
> +		if (status & CIRQ) {
> +			dev_dbg(mmc_dev(host->mmc), "SDIO Card Interrupt\n");
> +			mmc_signal_sdio_irq(host->mmc);
> +		}
> +	}
> +
>  	if (host->mrq == NULL) {
>  		OMAP_HSMMC_WRITE(host->base, STAT,
>  			OMAP_HSMMC_READ(host->base, STAT));
> @@ -649,10 +672,6 @@ static irqreturn_t omap_hsmmc_irq(int irq, void *dev_id)
>  		return IRQ_HANDLED;
>  	}
>  
> -	data = host->data;
> -	status = OMAP_HSMMC_READ(host->base, STAT);
> -	dev_dbg(mmc_dev(host->mmc), "IRQ Status is %x\n", status);
> -
>  	if (status & ERR) {
>  #ifdef CONFIG_MMC_DEBUG
>  		omap_hsmmc_report_irq(host, status);
> @@ -1254,6 +1273,25 @@ static int omap_hsmmc_get_ro(struct mmc_host *mmc)
>  	return mmc_slot(host).get_ro(host->dev, 0);
>  }
>  
> +static void omap_hsmmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
> +{
> +	struct omap_hsmmc_host *host = mmc_priv(mmc);
> +
> +	host->sdio_int = enable;
> +	if (enable) {
> +		OMAP_HSMMC_WRITE(host->base, ISE,
> +			(OMAP_HSMMC_READ(host->base, ISE) | CIRQ_ENABLE));
> +		OMAP_HSMMC_WRITE(host->base, IE,
> +			(OMAP_HSMMC_READ(host->base, IE) | CIRQ_ENABLE));
> +	} else {
> +		OMAP_HSMMC_WRITE(host->base, IE,
> +			(OMAP_HSMMC_READ(host->base, IE) & (~CIRQ_ENABLE)));
> +		OMAP_HSMMC_WRITE(host->base, ISE,
> +			(OMAP_HSMMC_READ(host->base, ISE) & (~CIRQ_ENABLE)));
> +	}
> +
> +}
> +
>  static void omap_hsmmc_conf_bus_power(struct omap_hsmmc_host *host)
>  {
>  	u32 hctl, capa, value;
> @@ -1519,7 +1557,7 @@ static const struct mmc_host_ops omap_hsmmc_ops = {
>  	.set_ios = omap_hsmmc_set_ios,
>  	.get_cd = omap_hsmmc_get_cd,
>  	.get_ro = omap_hsmmc_get_ro,
> -	/* NYET -- enable_sdio_irq */
> +	.enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
>  };
>  
>  static const struct mmc_host_ops omap_hsmmc_ps_ops = {
> @@ -1529,7 +1567,7 @@ static const struct mmc_host_ops omap_hsmmc_ps_ops = {
>  	.set_ios = omap_hsmmc_set_ios,
>  	.get_cd = omap_hsmmc_get_cd,
>  	.get_ro = omap_hsmmc_get_ro,
> -	/* NYET -- enable_sdio_irq */
> +	.enable_sdio_irq = omap_hsmmc_enable_sdio_irq,
>  };
>  
>  #ifdef CONFIG_DEBUG_FS
> @@ -1657,6 +1695,7 @@ static int __init omap_hsmmc_probe(struct platform_device *pdev)
>  	host->mapbase	= res->start;
>  	host->base	= ioremap(host->mapbase, SZ_4K);
>  	host->power_mode = -1;
> +	host->sdio_int = 0;
>  
>  	platform_set_drvdata(pdev, host);
>  	INIT_WORK(&host->mmc_carddetect_work, omap_hsmmc_detect);
> @@ -1744,6 +1783,10 @@ static int __init omap_hsmmc_probe(struct platform_device *pdev)
>  	if (mmc_slot(host).nonremovable)
>  		mmc->caps |= MMC_CAP_NONREMOVABLE;
>  
> +	mmc->caps |= MMC_CAP_SDIO_IRQ;
> +	OMAP_HSMMC_WRITE(host->base, CON,
> +			OMAP_HSMMC_READ(host->base, CON) | (CTPL | CLKEXTFREE));
> +
>  	omap_hsmmc_conf_bus_power(host);
>  
>  	/* Select DMA lines */

-- 
Sincerely yours,
Mike.

--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html

[Index of Archives]     [Linux USB Devel]     [Linux Media]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux