On Wed, Jul 16, 2014 at 03:48:19PM +0200, Vlastimil Babka wrote: > The migration scanner skips PageBuddy pages, but does not consider their order > as checking page_order() is generally unsafe without holding the zone->lock, > and acquiring the lock just for the check wouldn't be a good tradeoff. > > Still, this could avoid some iterations over the rest of the buddy page, and > if we are careful, the race window between PageBuddy() check and page_order() > is small, and the worst thing that can happen is that we skip too much and miss > some isolation candidates. This is not that bad, as compaction can already fail > for many other reasons like parallel allocations, and those have much larger > race window. > > This patch therefore makes the migration scanner obtain the buddy page order > and use it to skip the whole buddy page, if the order appears to be in the > valid range. > > It's important that the page_order() is read only once, so that the value used > in the checks and in the pfn calculation is the same. But in theory the > compiler can replace the local variable by multiple inlines of page_order(). > Therefore, the patch introduces page_order_unsafe() that uses ACCESS_ONCE to > prevent this. > > Testing with stress-highalloc from mmtests shows a 15% reduction in number of > pages scanned by migration scanner. The reduction is >60% with __GFP_NO_KSWAPD > allocations, along with success rates better by few percent. > This change is also a prerequisite for a later patch which is detecting when > a cc->order block of pages contains non-buddy pages that cannot be isolated, > and the scanner should thus skip to the next block immediately. > > Signed-off-by: Vlastimil Babka <vbabka@xxxxxxx> > Reviewed-by: Zhang Yanfei <zhangyanfei@xxxxxxxxxxxxxx> > Acked-by: Minchan Kim <minchan@xxxxxxxxxx> Acked-by: Mel Gorman <mgorman@xxxxxxx> -- Mel Gorman SUSE Labs -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxx. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>