refresh_zone_stat_thresholds function has two loops which is expensive for
higher number of CPUs and NUMA nodes.
Below is the rough estimation of total iterations done by these loops
based on number of NUMA and CPUs.
Total number of iterations: nCPU * 2 * Numa * mCPU
Where:
nCPU = total number of CPUs
Numa = total number of NUMA nodes
mCPU = mean value of total CPUs (e.g., 512 for 1024 total CPUs)
For the system under test with 16 NUMA nodes and 1024 CPUs, this
results in a substantial increase in the number of loop iterations
during boot-up when NUMA is enabled:
No NUMA = 1024*2*1*512 = 1,048,576 : Here refresh_zone_stat_thresholds
takes around 224 ms total for all the CPUs in the system under test.
16 NUMA = 1024*2*16*512 = 16,777,216 : Here refresh_zone_stat_thresholds
takes around 4.5 seconds total for all the CPUs in the system under test.
Calling this for each CPU is expensive when there are large number
of CPUs along with multiple NUMAs. Fix this by deferring
refresh_zone_stat_thresholds to be called later at once when all the
secondary CPUs are up. Also, register the DYN hooks to keep the
existing hotplug functionality intact.
Signed-off-by: Saurabh Sengar <ssengar@xxxxxxxxxxxxxxxxxxx>
---
[V2]
- Move vmstat_late_init_done under CONFIG_SMP to fix
variable 'defined but not used' warning.
mm/vmstat.c | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)
diff --git a/mm/vmstat.c b/mm/vmstat.c
index 4e2dc067a654..fa235c65c756 100644
--- a/mm/vmstat.c
+++ b/mm/vmstat.c
@@ -1908,6 +1908,7 @@ static const struct seq_operations vmstat_op = {
#ifdef CONFIG_SMP
static DEFINE_PER_CPU(struct delayed_work, vmstat_work);
int sysctl_stat_interval __read_mostly = HZ;
+static int vmstat_late_init_done;
#ifdef CONFIG_PROC_FS
static void refresh_vm_stats(struct work_struct *work)
@@ -2110,7 +2111,8 @@ static void __init init_cpu_node_state(void)
static int vmstat_cpu_online(unsigned int cpu)
{
- refresh_zone_stat_thresholds();
+ if (vmstat_late_init_done)
+ refresh_zone_stat_thresholds();
if (!node_state(cpu_to_node(cpu), N_CPU)) {
node_set_state(cpu_to_node(cpu), N_CPU);
@@ -2142,6 +2144,14 @@ static int vmstat_cpu_dead(unsigned int cpu)
return 0;
}
+static int __init vmstat_late_init(void)
+{
+ refresh_zone_stat_thresholds();
+ vmstat_late_init_done = 1;
+
+ return 0;
+}
+late_initcall(vmstat_late_init);
#endif
struct workqueue_struct *mm_percpu_wq;
--
2.43.0
