On Wed 03-07-24 13:38:04, Andrew Morton wrote: > On Wed, 3 Jul 2024 10:45:56 +0800 xiujianfeng <xiujianfeng@xxxxxxxxxx> wrote: > > > > > > > On 2024/7/3 9:58, Andrew Morton wrote: > > > On Tue, 2 Jul 2024 12:57:28 +0000 Xiu Jianfeng <xiujianfeng@xxxxxxxxxx> wrote: > > > > > >> Introduce peak and rsvd.peak to v2 to show the historical maximum > > >> usage of resources, as in some scenarios it is necessary to configure > > >> the value of max/rsvd.max based on the peak usage of resources. > > > > > > "in some scenarios it is necessary" is not a strong statement. It > > > would be helpful to fully describe these scenarios so that others can > > > better understand the value of this change. > > > > > > > Hi Andrew, > > > > Is the following description acceptable for you? > > > > > > Since HugeTLB doesn't support page reclaim, enforcing the limit at > > page fault time implies that, the application will get SIGBUS signal > > if it tries to fault in HugeTLB pages beyond its limit. Therefore the > > application needs to know exactly how many HugeTLB pages it uses before > > hand, and the sysadmin needs to make sure that there are enough > > available on the machine for all the users to avoid processes getting > > SIGBUS. yes, this is pretty much a definition of hugetlb. > > When running some open-source software, it may not be possible to know > > the exact amount of hugetlb it consumes, so cannot correctly configure > > the max value. If there is a peak metric, we can run the open-source > > software first and then configure the max based on the peak value. I would push back on this. Hugetlb workloads pretty much require to know the number of hugetlb pages ahead of time. Because you need to preallocate them for the global hugetlb pool. What I am really missing in the above justification is an explanation of how come you know how to configure the global pool but you do not know that for a particular cgroup. How exactly do you configure the global pool then? -- Michal Hocko SUSE Labs
