[PATCH v5 2/8] soc/tegra: fuse: Use dev_err_probe for probe failures

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Currently, in tegra_fuse_probe() if clock/reset get fails, then the
driver prints an error if the error is not caused by -EPROBE_DEFER.
This can be improved by using dev_err_probe() instead.

So, return dev_err_probe() if clock/reset get fails.

Signed-off-by: Kartik <kkartik@xxxxxxxxxx>
---
 drivers/soc/tegra/fuse/fuse-tegra.c | 17 ++++-------------
 1 file changed, 4 insertions(+), 13 deletions(-)

diff --git a/drivers/soc/tegra/fuse/fuse-tegra.c b/drivers/soc/tegra/fuse/fuse-tegra.c
index a2c28f493a75..98805885158e 100644
--- a/drivers/soc/tegra/fuse/fuse-tegra.c
+++ b/drivers/soc/tegra/fuse/fuse-tegra.c
@@ -131,13 +131,8 @@ static int tegra_fuse_probe(struct platform_device *pdev)
 	fuse->phys = res->start;
 
 	fuse->clk = devm_clk_get(&pdev->dev, "fuse");
-	if (IS_ERR(fuse->clk)) {
-		if (PTR_ERR(fuse->clk) != -EPROBE_DEFER)
-			dev_err(&pdev->dev, "failed to get FUSE clock: %ld",
-				PTR_ERR(fuse->clk));
-
-		return PTR_ERR(fuse->clk);
-	}
+	if (IS_ERR(fuse->clk))
+		return dev_err_probe(&pdev->dev, PTR_ERR(fuse->clk), "failed to get FUSE clock\n");
 
 	platform_set_drvdata(pdev, fuse);
 	fuse->dev = &pdev->dev;
@@ -179,12 +174,8 @@ static int tegra_fuse_probe(struct platform_device *pdev)
 	}
 
 	fuse->rst = devm_reset_control_get_optional(&pdev->dev, "fuse");
-	if (IS_ERR(fuse->rst)) {
-		err = PTR_ERR(fuse->rst);
-		dev_err(&pdev->dev, "failed to get FUSE reset: %pe\n",
-			fuse->rst);
-		return err;
-	}
+	if (IS_ERR(fuse->rst))
+		return dev_err_probe(&pdev->dev, PTR_ERR(fuse->rst), "failed to get FUSE reset\n");
 
 	/*
 	 * FUSE clock is enabled at a boot time, hence this resume/suspend
-- 
2.34.1





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux