Re: [PATCH v2] Documentation/mm: Initial page table documentation

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jun 08, 2023 at 01:49:28PM +0200, Linus Walleij wrote:
> diff --git a/Documentation/mm/page_tables.rst b/Documentation/mm/page_tables.rst
> index 96939571d7bc..315d295d1740 100644
> --- a/Documentation/mm/page_tables.rst
> +++ b/Documentation/mm/page_tables.rst
> @@ -3,3 +3,134 @@
>  ===========
>  Page Tables
>  ===========
> +
> +Paged virtual memory was invented along with virtual memory as a concept in
> +1962 on the Ferranti Atlas Computer which was the first computer with paged
> +virtual memory. The feature migrated to newer computers and became a de facto
> +feature of all Unix-like systems as time went by. In 1985 the feature was
> +included in the Intel 80386, which was the CPU Linux 1.0 was developed on.
> +
> +Page tables map virtual addresses as seen by the CPU program counter into
> +physical addresses as seen on the external memory bus.
> +
> +Linux defines page tables as a hierarchy which is currently five levels in
> +height. The target architecture code for each supported architecture will then
> +map this to the restrictions of the target hardware.
> +
> +The physical address corresponding to the virtual address is often referenced
> +by the underlying physical page frame. The **page frame number** or **pfn**
> +is the physical address of the page (as seen on the external memory bus)
> +divided by `PAGE_SIZE`.
> +
> +Physical memory address 0 will be *pfn 0* and the highest pfn will be
> +the last page of physical memory the external address bus of the CPU can
> +address.
> +
> +With a page granularity of 4KB and a address range of 32 bits, pfn 0 is at
> +address 0x00000000, pfn 1 is at address 0x00004000, pfn 2 is at 0x00008000
> +and so on until we reach pfn 0x3ffff at 0xffffc000.
> +
> +As you can see, with 4KB pages the page base address uses bits 12-31 of the
> +address, and this is why `PAGE_SHIFT` in this case is defined as 12 and
> +`PAGE_SIZE` is usually defined in terms of the page shift as `(1 << PAGE_SHIFT)`
> +
> +Over time a deeper hierarchy has been developed in response to increasing memory
> +sizes. When Linux was created, 4KB pages and a single page table called
> +`swapper_pg_dir` with 1024 entries was used, covering 4MB which coincided with
> +the fact that Torvald's first computer had 4MB of physical memory. Entries in
> +this single table was referred to as *PTE*:s - page table entries.
> +
> +Over time the page table hierarchy has developed into this::
> +
> +  +-----+
> +  | PGD |
> +  +-----+
> +     |
> +     |   +-----+
> +     +-->| P4D |
> +         +-----+
> +            |
> +            |   +-----+
> +            +-->| PUD |
> +                +-----+
> +                   |
> +                   |   +-----+
> +                   +-->| PMD |
> +                       +-----+
> +                          |
> +                          |   +-----+
> +                          +-->| PTE |
> +                              +-----+
> +
> +
> +Symbols on the different levels of the page table hierarchy have the following
> +meaning beginning from the bottom:
> +
> +- **pte**, `pte_t`, `pteval_t` = **Page Table Entry** - mentioned earlier.
> +  The *pte* is an array of `PTRS_PER_PTE` elements of the `pteval_t` type, each
> +  mapping a single page of virtual memory to a single page of physical memory.
> +  The architecture defines the size and contents of `pteval_t`.
> +
> +  A typical example is that the `pteval_t` is a 32- or 64-bit value with the
> +  upper bits being a **pfn** (page frame number), and the lower bits being some
> +  architecture-specific bits such as memory protection.
> +
> +  The **entry** part of the name is a bit confusing because while in Linux 1.0
> +  this did refer to a single page table entry in the single top level page
> +  table, it was retrofitted to be an array of mapping elements when two-level
> +  page tables were first introduced, so the *pte* is the lowermost page
> +  *table*, not a page table *entry*.
> +
> +- **pmd**, `pmd_t`, `pmdval_t` = **Page Middle Directory**, the hierarchy right
> +  above the *pte*, with `PTRS_PER_PMD` references to the *pte*:s.
> +
> +- **pud**, `pud_t`, `pudval_t` = **Page Upper Directory** was introduced after
> +  the other levels to handle 4-level page tables. It is potentially unused,
> +  or *folded* as we will discuss later.
> +
> +- **p4d**, `p4d_t`, `p4dval_t` = **Page Level 4 Directory** was introduced to
> +  handle 5-level page tables after the *pud* was introduced. Now it was clear
> +  that we needed to replace *pgd*, *pmd*, *pud* etc with a figure indicating the
> +  directory level and that we cannot go on with ad hoc names any more. This
> +  is only used on systems which actually have 5 levels of page tables, otherwise
> +  it is folded.
> +
> +- **pgd**, `pgd_t`, `pgdval_t` = **Page Global Directory** - the Linux kernel
> +  main page table handling the PGD for the kernel memory is still found in
> +  `swapper_pg_dir`, but each userspace process in the system also has its own
> +  memory context and thus its own *pgd*, found in `struct mm_struct` which
> +  in turn is referenced to in each `struct task_struct`. So tasks have memory
> +  context in the form of a `struct mm_struct` and this in turn has a
> +  `struct pgt_t *pgd` pointer to the corresponding page global directory.
> +
> +To repeat: each level in the page table hierarchy is a *array of pointers*, so
> +the **pgd** contains `PTRS_PER_PGD` pointers to the next level below, **p4d**
> +contains `PTRS_PER_P4D` pointers to **pud** items and so on. The number of
> +pointers on each level is architecture-defined.::
> +
> +        PMD
> +  --> +-----+           PTE
> +      | ptr |-------> +-----+
> +      | ptr |-        | ptr |-------> PAGE
> +      | ptr | \       | ptr |
> +      | ptr |  \        ...
> +      | ... |   \
> +      | ptr |    \         PTE
> +      +-----+     +----> +-----+
> +                         | ptr |-------> PAGE
> +                         | ptr |
> +                           ...
> +
> +
> +Page Table Folding
> +==================
> +
> +If the architecture does not use all the page table levels, they can be *folded*
> +which means skipped, and all operations performed on page tables will be
> +compile-time augmented to just skip a level when accessing the next lower
> +level.
> +
> +Page table handling code that wishes to be architecture-neutral, such as the
> +virtual memory manager, will need to be written so that it traverses all of the
> +currently five levels. This style should also be preferred for
> +architecture-specific code, so as to be robust to future changes.

LGTM, thanks!

Reviewed-by: Bagas Sanjaya <bagasdotme@xxxxxxxxx>

-- 
An old man doll... just what I always wanted! - Clara

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux