Hi Johannes,
On 2022/8/3 am 12:28, Johannes Weiner wrote:
During proactive reclaim, we sometimes observe severe overreclaim,
with several thousand times more pages reclaimed than requested.
This trace was obtained from shrink_lruvec() during such an instance:
prio:0 anon_cost:1141521 file_cost:7767
nr_reclaimed:4387406 nr_to_reclaim:1047 (or_factor:4190)
nr=[7161123 345 578 1111]
While he reclaimer requested 4M, vmscan reclaimed close to 16G, most
of it by swapping. These requests take over a minute, during which the
write() to memory.reclaim is unkillably stuck inside the kernel.
Digging into the source, this is caused by the proportional reclaim
bailout logic. This code tries to resolve a fundamental conflict: to
reclaim roughly what was requested, while also aging all LRUs fairly
and in accordance to their size, swappiness, refault rates etc. The
way it attempts fairness is that once the reclaim goal has been
reached, it stops scanning the LRUs with the smaller remaining scan
targets, and adjusts the remainder of the bigger LRUs according to how
much of the smaller LRUs was scanned. It then finishes scanning that
remainder regardless of the reclaim goal.
This works fine if priority levels are low and the LRU lists are
comparable in size. However, in this instance, the cgroup that is
targeted by proactive reclaim has almost no files left - they've
already been squeezed out by proactive reclaim earlier - and the
remaining anon pages are hot. Anon rotations cause the priority level
to drop to 0, which results in reclaim targeting all of anon (a lot)
and all of file (almost nothing). By the time reclaim decides to bail,
it has scanned most or all of the file target, and therefor must also
scan most or all of the enormous anon target. This target is thousands
of times larger than the reclaim goal, thus causing the overreclaim.
The bailout code hasn't changed in years, why is this failing now?
The most likely explanations are two other recent changes in anon
reclaim:
1. Before the series starting with commit 5df741963d52 ("mm: fix LRU
balancing effect of new transparent huge pages"), the VM was
overall relatively reluctant to swap at all, even if swap was
configured. This means the LRU balancing code didn't come into play
as often as it does now, and mostly in high pressure situations
where pronounced swap activity wouldn't be as surprising.
2. For historic reasons, shrink_lruvec() loops on the scan targets of
all LRU lists except the active anon one, meaning it would bail if
the only remaining pages to scan were active anon - even if there
were a lot of them.
Before the series starting with commit ccc5dc67340c ("mm/vmscan:
make active/inactive ratio as 1:1 for anon lru"), most anon pages
would live on the active LRU; the inactive one would contain only a
handful of preselected reclaim candidates. After the series, anon
gets aged similarly to file, and the inactive list is the default
for new anon pages as well, making it often the much bigger list.
As a result, the VM is now more likely to actually finish large
anon targets than before.
Change the code such that only one SWAP_CLUSTER_MAX-sized nudge toward
the larger LRU lists is made before bailing out on a met reclaim goal.
This fixes the extreme overreclaim problem.
Fairness is more subtle and harder to evaluate. No obvious misbehavior
was observed on the test workload, in any case. Conceptually, fairness
should primarily be a cumulative effect from regular, lower priority
scans. Once the VM is in trouble and needs to escalate scan targets to
make forward progress, fairness needs to take a backseat. This is also
acknowledged by the myriad exceptions in get_scan_count(). This patch
makes fairness decrease gradually, as it keeps fairness work static
over increasing priority levels with growing scan targets. This should
make more sense - although we may have to re-visit the exact values.
Signed-off-by: Johannes Weiner <hannes@xxxxxxxxxxx>
---
mm/vmscan.c | 10 ++++------
1 file changed, 4 insertions(+), 6 deletions(-)
diff --git a/mm/vmscan.c b/mm/vmscan.c
index f7d9a683e3a7..1cc0c6666787 100644
--- a/mm/vmscan.c
+++ b/mm/vmscan.c
@@ -2897,8 +2897,8 @@ static void shrink_lruvec(struct lruvec *lruvec, struct scan_control *sc)
enum lru_list lru;
unsigned long nr_reclaimed = 0;
unsigned long nr_to_reclaim = sc->nr_to_reclaim;
+ bool proportional_reclaim;
struct blk_plug plug;
- bool scan_adjusted;
get_scan_count(lruvec, sc, nr);
@@ -2916,8 +2916,8 @@ static void shrink_lruvec(struct lruvec *lruvec, struct scan_control *sc)
* abort proportional reclaim if either the file or anon lru has already
* dropped to zero at the first pass.
*/
- scan_adjusted = (!cgroup_reclaim(sc) && !current_is_kswapd() &&
- sc->priority == DEF_PRIORITY);
+ proportional_reclaim = (!cgroup_reclaim(sc) && !current_is_kswapd() &&
+ sc->priority == DEF_PRIORITY);
blk_start_plug(&plug);
while (nr[LRU_INACTIVE_ANON] || nr[LRU_ACTIVE_FILE] ||
@@ -2937,7 +2937,7 @@ static void shrink_lruvec(struct lruvec *lruvec, struct scan_control *sc)
cond_resched();
- if (nr_reclaimed < nr_to_reclaim || scan_adjusted)
+ if (nr_reclaimed < nr_to_reclaim || proportional_reclaim)
continue;
/*
@@ -2988,8 +2988,6 @@ static void shrink_lruvec(struct lruvec *lruvec, struct scan_control *sc)
nr_scanned = targets[lru] - nr[lru];
nr[lru] = targets[lru] * (100 - percentage) / 100;
nr[lru] -= min(nr[lru], nr_scanned);
We should not just remove the following line because kswapd may also
call this function and there is no side effect to do scan adjust for
kswapd,so it may be better to change like this:
+ if (current_is_kswapd())
scan_adjusted = true;
-
- scan_adjusted = true
}
blk_finish_plug(&plug);
sc->nr_reclaimed += nr_reclaimed;
Thanks
Hongchen Zhang
