On Wed, 24 Nov 2021 at 13:01, Zhaoyang Huang <huangzhaoyang@xxxxxxxxx> wrote: > > On Wed, Nov 24, 2021 at 5:23 PM Ard Biesheuvel <ardb@xxxxxxxxxx> wrote: > > > > On Wed, 24 Nov 2021 at 09:08, Zhaoyang Huang <huangzhaoyang@xxxxxxxxx> wrote: > > > > > > On Tue, Nov 23, 2021 at 5:58 PM Ard Biesheuvel <ardb@xxxxxxxxxx> wrote: > > > > > > > > On Tue, 23 Nov 2021 at 10:13, Huangzhaoyang <huangzhaoyang@xxxxxxxxx> wrote: > > > > > > > > > > From: Zhaoyang Huang <zhaoyang.huang@xxxxxxxxxx> > > > > > > > > > > Since there is no PTE_CONT when rodata_full in ARM64, introducing a > > > > > hook function to apply PTE_CONT on the proper page blocks. > > > > > > > > > > > > > Given the discussion around your previous patch, I would expect a > > > > meticulous explanation here why it is guaranteed to be safe to > > > > manipulate the PTE_CONT attribute like this, and how the proposed > > > > logic is correct for all supported page sizes. > > > > > > > > Without using an intermediate invalid mapping for the entire range, > > > > this is never going to work reliably (this is the break-before-make > > > > requirement). And given that marking the entire block invalid will > > > > create intermediate states that are not permitted (a valid PTE_CONT > > > > mapping and an invalid ~PTE_CONT mapping covering the same VA), the > > > > only way to apply changes like these is to temporarily switch all CPUs > > > > to a different translation via TTBR1. And this is not going to happen. > > > As there is no safe way to modify PTE_CONT on a live mapping, please > > > forget all previous patches except current one. > > > > OK > > > > > > > > > > Also, you never replied to my question regarding the use case and the > > > > performance gain. > > > In our android based system, the multimedia related cases suffers from > > > small pte granularity mostly which use high order page blocks quite a > > > lot. The performance gap even be visible. > > > > OK, good to know. > > > > > > > > > > In summary, NAK to this patch or any of the previous ones regarding > > > > PTE_CONT. If you do insist on pursuing this further, please provide an > > > > elaborate and rock solid explanation why your approach is 100% valid > > > > and correct (for all page sizes). And make sure you include an > > > > explanation how your changes comply with the architectural > > > > break-before-make requirements around PTE_CONT attributes. > > > IMHO, It is safe to modify the page block's pte undering > > > *arch_alloc/free_pages* as there is no one else aware of it. > > > > Whether the software is 'aware' or not is irrelevant. Speculative > > accesses could be made at any time, and these will trigger a page > > table walk if no cached TLB entries exist for the region. If more than > > one cached TLB entry exists (which would be the case if an adjacent > > entry has the PTE_CONT attribute but not the entry itself), you will > > hit a TLB conflict abort. > Could it be a risk that a speculative load racing with setting pte > from VALID to INVALID? Theorizing about what might go wrong is not very useful. The architecture simply does not permit what you are proposing here, and this is reason enough not to do it. The ARM ARM says the following [DDI0487G.a D5.2 "Misprogramming of the Contiguous bit"] """ If one or more of the following errors is made in programming the translation tables, the TLB might contain overlapping entries: - One or more of the contiguous translation table entries does not have the Contiguous bit set to 1. - One or more of the contiguous translation table entries holds an output address that is not consistent with all of the entries pointing to the same aligned contiguous address range. - The attributes and permissions of the contiguous entries are not all the same. Such misprogramming of the translation tables means the output address, memory permissions, or attributes for a lookup might be corrupted, and might be equal to values that are not consistent with any of the programmed translation table values. In some implementations, such misprogramming might also give rise to a TLB Conflict abort. """ This means that none of the entries in the contiguous group are reliable when only one entry in the group deviates, and in addition to TLB conflict aborts, you may trigger all kinds of corruption due to the output address being bogus. So NAK again.
