On Thu, Sep 02, 2021 at 04:19:23PM +0800, Yu Zhang wrote: > On Wed, Sep 01, 2021 at 09:07:59AM -0700, Andy Lutomirski wrote: > > On 9/1/21 3:24 AM, Yu Zhang wrote: > > > On Tue, Aug 31, 2021 at 09:53:27PM -0700, Andy Lutomirski wrote: > > >> > > >> > > >> On Thu, Aug 26, 2021, at 7:31 PM, Yu Zhang wrote: > > >>> On Thu, Aug 26, 2021 at 12:15:48PM +0200, David Hildenbrand wrote: > > >> > > >>> Thanks a lot for this summary. A question about the requirement: do we or > > >>> do we not have plan to support assigned device to the protected VM? > > >>> > > >>> If yes. The fd based solution may need change the VFIO interface as well( > > >>> though the fake swap entry solution need mess with VFIO too). Because: > > >>> > > >>> 1> KVM uses VFIO when assigning devices into a VM. > > >>> > > >>> 2> Not knowing which GPA ranges may be used by the VM as DMA buffer, all > > >>> guest pages will have to be mapped in host IOMMU page table to host pages, > > >>> which are pinned during the whole life cycle fo the VM. > > >>> > > >>> 3> IOMMU mapping is done during VM creation time by VFIO and IOMMU driver, > > >>> in vfio_dma_do_map(). > > >>> > > >>> 4> However, vfio_dma_do_map() needs the HVA to perform a GUP to get the HPA > > >>> and pin the page. > > >>> > > >>> But if we are using fd based solution, not every GPA can have a HVA, thus > > >>> the current VFIO interface to map and pin the GPA(IOVA) wont work. And I > > >>> doubt if VFIO can be modified to support this easily. > > >>> > > >>> > > >> > > >> Do you mean assigning a normal device to a protected VM or a hypothetical protected-MMIO device? > > >> > > >> If the former, it should work more or less like with a non-protected VM. mmap the VFIO device, set up a memslot, and use it. I'm not sure whether anyone will actually do this, but it should be possible, at least in principle. Maybe someone will want to assign a NIC to a TDX guest. An NVMe device with the understanding that the guest can't trust it wouldn't be entirely crazy ether. > > >> > > >> If the latter, AFAIK there is no spec for how it would work even in principle. Presumably it wouldn't work quite like VFIO -- instead, the kernel could have a protection-virtual-io-fd mechanism, and that fd could be bound to a memslot in whatever way we settle on for binding secure memory to a memslot. > > >> > > > > > > Thanks Andy. I was asking the first scenario. > > > > > > Well, I agree it is doable if someone really want some assigned > > > device in TD guest. As Kevin mentioned in his reply, HPA can be > > > generated, by extending VFIO with a new mapping protocol which > > > uses fd+offset, instead of HVA. > > > > I'm confused. I don't see why any new code is needed for this at all. > > Every proposal I've seen for handling TDX memory continues to handle TDX > > *shared* memory exactly like regular guest memory today. The only > > differences are that more hole punching will be needed, which will > > require lightweight memslots (to have many of them), memslots with > > holes, or mappings backing memslots with holes (which can be done with > > munmap() on current kernels). > > Thanks for pointing this out. And yes, for DMAs not capable of encryption( > which is the case in current TDX). GUP shall work as it is in VFIO. :) > > > > > So you can literally just mmap a VFIO device and expect it to work, > > exactly like it does right now. Whether the guest will be willing to > > use the device will depend on the guest security policy (all kinds of > > patches about that are flying around), but if the guest tries to use it, > > it really should just work. > > > > But I think there's still problem. For now, > > 1> Qemu mmap()s all GPAs into its HVA space, when the VM is created. > 2> With no idea which part of guest memory shall be shared, VFIO will just > set up the IOPT, by mapping whole GPA ranges in IOPT. actually, it's not GPA in IOPT. It's IOVA in IOPT, and the IOVA is equal to GPA in this case. > 3> And those GPAs are actually private ones, with no shared-bit set. > in Guest, IOVA is set to GPA (without shared bit) for shared memory in TDX now. > Later when guest tries to perform a DMA(using a shared GPA), IO page fault > shall happen. So, this situation should not happen. > > > > > > Another issue is current TDX does not support DMA encryption, and > > > only shared GPA memory shall be mapped in the VT-d. So to support > > > this, KVM may need to work with VFIO to dynamically program host > > > IOPT(IOMMU Page Table) when TD guest notifies a shared GFN range(e.g., > > > with a MAP_GPA TDVMCALL), instead of prepopulating the IOPT at VM > > > creation time, by mapping entire GFN ranges of a guest. > > > > Given that there is no encrypted DMA support, shouldn't the only IOMMU > > mappings (real host-side IOMMU) that point at guest memory be for > > non-encrypted DMA? I don't see how this interacts at all. If the guest > > tries to MapGPA to turn a shared MMIO page into private, the host should > > fail the hypercall because the operation makes no sense. > > > > It is indeed the case that, with a TDX guest, MapGPA shared->private to > > a page that was previously used for unencrypted DMA will need to avoid > > having IOPT entries to the new private page, but even that doesn't seem > > particularly bad. The fd+special memslot proposal for private memory > > means that shared *backing store* pages never actually transition > > between shared and private without being completely freed. > > > > As far as I can tell, the actual problem you're referring to is: > > > > >>> 2> Not knowing which GPA ranges may be used by the VM as DMA buffer, all > > >>> guest pages will have to be mapped in host IOMMU page table to host > > pages, > > >>> which are pinned during the whole life cycle fo the VM. > > Yes. That's the primary concern. :) > > > > > In principle, you could actually initialize a TDX guest with all of its > > memory shared and all of it mapped in the host IOMMU. When a guest > > turns some pages private, user code could punch a hole in the memslot, > > allocate private memory at that address, but leave the shared backing > > store in place and still mapped in the host IOMMU. The result would be > > that guest-initiated DMA to the previously shared address would actually > > work but would hit pages that are invisible to the guest. And a whole > > bunch of memory would be waste, but the whole system should stll work. > > Do you mean to let VFIO & IOMMU to treat all guest memory as shared first, > and then just allocate the private pages in another backing store? I guess just a curious question. what if this shared->private conversion is on MMIO ranges that are mapped into the device? do you have enough info to get MMIO hpa for the private mapping? Thanks Yan > that could work, but with the cost of allocating roughly 2x physical pages > of the guest RAM size. After all, the shared pages shall be only a small > part of guest memory. > > If device assignment is desired in current TDX. My understanding of the > enabling work would be like this: > 1> Change qemu to not trigger VFIO_IOMMU_MAP_DMA for the TD, thus no IOPT > prepopulated, and no physical page allocated. > 2> KVM forwards MapGPA(private -> shared) request to Qemu. > 3> Qemu asks VFIO to pin and map the shared GPAs. > > For private -> shared transitions, the memslot punching, IOPT unmapping, > and iotlb flushing are necessary. Possibly new interface between VFIO and > KVM is needed. > > But actually I am not sure if people really want assigned device in current > TDX. Bottleneck of the performance should be the copying to/from swiotlb > buffers. > > B.R. > Yu >
