Re: [RFC] mm: optimise generic_file_read_iter

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 8/6/21 7:48 AM, Al Viro wrote:
> On Fri, Aug 06, 2021 at 12:42:43PM +0100, Pavel Begunkov wrote:
>> Unless direct I/O path of generic_file_read_iter() ended up with an
>> error or a short read, it doesn't use inode. So, load inode and size
>> later, only when they're needed. This cuts two memory reads and also
>> imrpoves code generation, e.g. loads from stack.
> 
> ... and the same question here.
> 
>> NOTE: as a side effect, it reads inode->i_size after ->direct_IO(), and
>> I'm not sure whether that's valid, so would be great to get feedback
>> from someone who knows better.
> 
> Ought to be safe, I think, but again, how much effect have you observed
> from the patch?

Ran a quick test here, doing polled IO (~3.3M IOPS) and we reduce the
overhead of generic_file_read_iter() from 1.5% of the runtime to 1.2%.
Noticeable. Will improve once we stop digging into the inode on the
io_uring side.

Anyway, just one data point, perhaps Pavel has some too.


-- 
Jens Axboe





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux