On Sat, 2011-10-08 at 18:25 +0800, Minchan Kim wrote:
> On Sat, Oct 08, 2011 at 01:56:52PM +0800, Shaohua Li wrote:
> > On Sat, 2011-10-08 at 11:35 +0800, Shaohua Li wrote:
> > > On Sat, 2011-10-08 at 11:19 +0800, David Rientjes wrote:
> > > > On Sat, 8 Oct 2011, Shaohua Li wrote:
> > > >
> > > > > has_under_min_watermark_zone is used to detect if there is GFP_ATOMIC allocation
> > > > > failure risk. For a high end_zone, if any zone below or equal to it has min
> > > > > matermark ok, we have no risk. But current logic is any zone has min watermark
> > > > > not ok, then we have risk. This is wrong to me.
> > > > >
> > > > > Signed-off-by: Shaohua Li <shaohua.li@xxxxxxxxx>
> > > > > ---
> > > > > mm/vmscan.c | 7 ++++---
> > > > > 1 file changed, 4 insertions(+), 3 deletions(-)
> > > > >
> > > > > Index: linux/mm/vmscan.c
> > > > > ===================================================================
> > > > > --- linux.orig/mm/vmscan.c 2011-09-27 15:09:29.000000000 +0800
> > > > > +++ linux/mm/vmscan.c 2011-09-27 15:14:45.000000000 +0800
> > > > > @@ -2463,7 +2463,7 @@ loop_again:
> > > > >
> > > > > for (priority = DEF_PRIORITY; priority >= 0; priority--) {
> > > > > unsigned long lru_pages = 0;
> > > > > - int has_under_min_watermark_zone = 0;
> > > > > + int has_under_min_watermark_zone = 1;
> > > >
> > > > bool
> > > >
> > > > >
> > > > > /* The swap token gets in the way of swapout... */
> > > > > if (!priority)
> > > > > @@ -2594,9 +2594,10 @@ loop_again:
> > > > > * means that we have a GFP_ATOMIC allocation
> > > > > * failure risk. Hurry up!
> > > > > */
> > > > > - if (!zone_watermark_ok_safe(zone, order,
> > > > > + if (has_under_min_watermark_zone &&
> > > > > + zone_watermark_ok_safe(zone, order,
> > > > > min_wmark_pages(zone), end_zone, 0))
> > > > > - has_under_min_watermark_zone = 1;
> > > > > + has_under_min_watermark_zone = 0;
> > > > > } else {
> > > > > /*
> > > > > * If a zone reaches its high watermark,
> > > >
> > > > Ignore checking the min watermark for a moment and consider if all zones
> > > > are above the high watermark (a situation where kswapd does not need to
> > > > do aggressive reclaim), then has_under_min_watermark_zone doesn't get
> > > > cleared and never actually stalls on congestion_wait(). Notice this is
> > > > congestion_wait() and not wait_iff_congested(), so the clearing of
> > > > ZONE_CONGESTED doesn't prevent this.
> > > if all zones are above the high watermark, we will have i < 0 when
> > > detecting the highest imbalanced zone, and the whole loop will end
> > > without run into congestion_wait().
> > > or I can add a clearing has_under_min_watermark_zone in the else block
> > > to be safe.
> > Subject: vmscan: correctly detect GFP_ATOMIC allocation failure -v2
> >
> > has_under_min_watermark_zone is used to detect if there is GFP_ATOMIC allocation
> > failure risk. For a high end_zone, if any zone below or equal to it has min
> > matermark ok, we have no risk. But current logic is any zone has min watermark
> > not ok, then we have risk. This is wrong to me.
>
> I think it's not a right or wrong problem but a policy stuff.
> If we are going to start busy reclaiming for atomic allocation
> after we see all lower zones' min water mark pages are already consumed
> It could make you go through long latency and is likely to fail atomic allocation
> stream(Because, there is nothing to do for aotmic allocation fail in direct reclaim
> so kswapd should always do best effort for it)
>
> I don't mean you are wrong but we are very careful about this
> and at least need some experiments with atomic allocaion stream, I think.
yes. this is a policy problem. I just don't want the kswapd keep running
even there is no immediate risk of atomic allocation fail.
One problem here is end_zone could be high, and low zone always doesn't
meet min watermark. So kswapd keeps running without a wait and builds
big priority.
Thanks,
Shaohua
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxx. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>