> > > + if (x_intercept < limit) {
> > > + x_intercept = limit; /* auxiliary control line */
> > > + setpoint += span;
> > > + pos_ratio >>= 1;
> > > + }
> > And here you stretch the control area upto the global dirty limit. I
> > understand you maybe don't want to be really strict and cut control area at
> > bdi_thresh but your choice looks like too benevolent - when you have
> > several active bdi's with different speeds this will effectively erase
> > difference between them, won't it? E.g. with 10 bdi's (x_intercept -
> > bdi_dirty) / (x_intercept - setpoint) is going to be close to 1 unless
> > bdi_dirty really heavily exceeds bdi_thresh.
>
> Yes the auxiliary control line could be very flat (small slope).
>
> However it's not normal for the bdi dirty pages to fall into the
> range of auxiliary control line at all. And once it takes effect,
> the pos_ratio is at most 0.5 (which is the value at the connection
> point with the main bdi control line) which is strong enough to pull
> the dirty pages off the auxiliary bdi control line and into the scope
> of main bdi control line.
>
> The auxiliary control line is intended for bringing down the bdi_dirty
> of the USB key before 250s (where the "pos bandwidth" line keeps low):
>
> http://www.kernel.org/pub/linux/kernel/people/wfg/writeback/dirty-throttling-v6/1UKEY+1HDD-3G/ext4-4dd-1M-8p-2945M-20%25-2.6.38-rc5-dt6+-2011-02-22-09-46/balance_dirty_pages-pages.png
>
> After that the bdi_dirty will fluctuate around bdi_thresh and won't
> grow high and step into the scope of the auxiliary control line.
Note that the main/auxiliary bdi control lines won't take effect at
the same time: the main bdi control lines works around and under the
bdi setpoint, and the auxiliary line takes over in the higher scope up
to @limit.
In the 1UKEY+1HDD test case, the bdi_dirty of the UKEY rushes at the
free run stage when global dirty pages are smaller than (thresh+bg_thresh)/2.
So it will be initially under the control the auxiliary line. Hence the
dirtier task will progress at 1/4 to 1/2 of the UKEY's write bandwidth.
This will bring down the bdi_dirty reasonably fast while still allowing
the dirtier task to make some progress.
The connection point of the main/auxiliary control lines has pos_ratio=0.5.
After 250 second, the main bdi control line takes over, indicated by
the bdi_dirty fluctuating around bdi setpoint and the position rate
(green line) fluctuating around the base ratelimit(blue line).
Thanks,
Fengguang
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@xxxxxxxxx. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/
Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>
