Re: [PATCH 4/6] mm/hmm: add output flag for compound page mapping

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 5/8/20 12:51 PM, Christoph Hellwig wrote:
On Fri, May 08, 2020 at 12:20:07PM -0700, Ralph Campbell wrote:
hmm_range_fault() returns an array of page frame numbers and flags for
how the pages are mapped in the requested process' page tables. The PFN
can be used to get the struct page with hmm_pfn_to_page() and the page size
order can be determined with compound_order(page) but if the page is larger
than order 0 (PAGE_SIZE), there is no indication that the page is mapped
using a larger page size. To be fully general, hmm_range_fault() would need
to return the mapping size to handle cases like a 1GB compound page being
mapped with 2MB PMD entries. However, the most common case is the mapping
size the same as the underlying compound page size.
Add a new output flag to indicate this so that callers know it is safe to
use a large device page table mapping if one is available.

Why do you need the flag?  The caller should be able to just use
page_size() (or willys new thp_size helper).


The question is whether or not a large page can be mapped with smaller
page table entries with different permissions. If one process has a 2MB
page mapped with 4K PTEs with different read/write permissions, I don't think
it would be OK for a device to map the whole 2MB with write access enabled.
The flag is supposed to indicate that the whole page can be mapped by the
device with the indicated read/write permissions.




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux