Re: [PATCH v5 17/17] powerpc/32s: Enable CONFIG_VMAP_STACK

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2/7/20 12:28 AM, Christophe Leroy wrote:


On 02/07/2020 06:13 AM, Christophe Leroy wrote:


Le 06/02/2020 à 21:31, Guenter Roeck a écrit :
On Sat, Dec 21, 2019 at 08:32:38AM +0000, Christophe Leroy wrote:
A few changes to retrieve DAR and DSISR from struct regs
instead of retrieving them directly, as they may have
changed due to a TLB miss.

Also modifies hash_page() and friends to work with virtual
data addresses instead of physical ones. Same on load_up_fpu()
and load_up_altivec().

Signed-off-by: Christophe Leroy <christophe.leroy@xxxxxx>

This patch results in qemu boot failures (mac99 with pmac32_defconfig).
Images fail silently; there is no console output. Reverting the patch
fixes the problem. Bisect log is attached below.

Assuming this was tested on real hardware, am I correct to assume that qemu
for ppc32 (more specifically, qemu's mac99 and g3beige machines) no longer
works with the upstream kernel ?

Before submitting the series, I successfully tested:
- Real HW with powerpc 8xx
- Real HW with powerpc 832x
- Qemu's mac99

I'll re-check the upstream kernel.


This is still working for me with the upstream kernel:


Interesting. What is your kernel configuration, your qemu version, and
your qemu command line ?

It works for me with CONFIG_VMAP_STACK=n, but not with pmac32_defconfig.

Thanks,
Guenter





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux