On Thu, Dec 19, 2019 at 05:07:43PM -0400, Jason Gunthorpe wrote: > On Thu, Dec 19, 2019 at 12:30:31PM -0800, John Hubbard wrote: > > On 12/19/19 5:26 AM, Leon Romanovsky wrote: > > > On Mon, Dec 16, 2019 at 02:25:12PM -0800, John Hubbard wrote: > > > > Hi, > > > > > > > > This implements an API naming change (put_user_page*() --> > > > > unpin_user_page*()), and also implements tracking of FOLL_PIN pages. It > > > > extends that tracking to a few select subsystems. More subsystems will > > > > be added in follow up work. > > > > > > Hi John, > > > > > > The patchset generates kernel panics in our IB testing. In our tests, we > > > allocated single memory block and registered multiple MRs using the single > > > block. > > > > > > The possible bad flow is: > > > ib_umem_geti() -> > > > pin_user_pages_fast(FOLL_WRITE) -> > > > internal_get_user_pages_fast(FOLL_WRITE) -> > > > gup_pgd_range() -> > > > gup_huge_pd() -> > > > gup_hugepte() -> > > > try_grab_compound_head() -> > > > > Hi Leon, > > > > Thanks very much for the detailed report! So we're overflowing... > > > > At first look, this seems likely to be hitting a weak point in the > > GUP_PIN_COUNTING_BIAS-based design, one that I believed could be deferred > > (there's a writeup in Documentation/core-api/pin_user_page.rst, lines > > 99-121). Basically it's pretty easy to overflow the page->_refcount > > with huge pages if the pages have a *lot* of subpages. > > > > We can only do about 7 pins on 1GB huge pages that use 4KB subpages. > > Considering that establishing these pins is entirely under user > control, we can't have a limit here. > > If the number of allowed pins are exhausted then the > pin_user_pages_fast() must fail back to the user. > > > 3. It would be nice if I could reproduce this. I have a two-node mlx5 Infiniband > > test setup, but I have done only the tiniest bit of user space IB coding, so > > if you have any test programs that aren't too hard to deal with that could > > possibly hit this, or be tweaked to hit it, I'd be grateful. Keeping in mind > > that I'm not an advanced IB programmer. At all. :) > > Clone this: > > https://github.com/linux-rdma/rdma-core.git > > Install all the required deps to build it (notably cython), see the README.md > > $ ./build.sh > $ build/bin/run_tests.py > > If you get things that far I think Leon can get a reproduction for you I'm not so optimistic about that. Thanks > > Jason
