On Wed, 2011-05-18 at 08:21 +0100, Ian Campbell wrote: > On Wed, 2011-05-18 at 07:57 +0100, Vasiliy G Tolstov wrote: > > On Tue, 2011-05-17 at 23:44 +0200, Daniel Kiper wrote: > > > + Memory could be hotplugged in following steps: > > > + > > > + 1) dom0: xl mem-max <domU> <maxmem> > > > + where <maxmem> is >= requested memory size, > > > + > > > + 2) dom0: xl mem-set <domU> <memory> > > > + where <memory> is requested memory size; alternatively memory > > > + could be added by writing proper value to > > > + /sys/devices/system/xen_memory/xen_memory0/target or > > > + /sys/devices/system/xen_memory/xen_memory0/target_kb on dumU, > > > + > > > + 3) domU: for i in /sys/devices/system/memory/memory*/state; do \ > > > + [ "`cat "$i"`" = offline ] && echo online > "$i"; done > > > + > > > Very good. Is that possible to eliminate step 3 ? And do it automatic if > > domU runs with specific xen balloon param? > > When we faced the same question WRT VCPU hotplug we ended up using a > udev rule. Presumably the same could be done here. In the VCPU case the > rule is: > > ACTION=="add", SUBSYSTEM=="cpu", RUN+="/bin/sh -c '[ ! -e /sys$devpath/online ] || echo 1 > /sys$devpath/online'" > > Presumably the memory one will be broadly similar. > > Ian. > Ok. very good solution. Thank's. -- Vasiliy G Tolstov <v.tolstov@xxxxxxxxx> Selfip.Ru -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxxx For more info on Linux MM, see: http://www.linux-mm.org/ . Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/ Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>