On Fri, 2011-05-13 at 15:03 +0100, Mel Gorman wrote: > Changelog since V1 > o kswapd should sleep if need_resched > o Remove __GFP_REPEAT from GFP flags when speculatively using high > orders so direct/compaction exits earlier > o Remove __GFP_NORETRY for correctness > o Correct logic in sleeping_prematurely > o Leave SLUB using the default slub_max_order > > There are a few reports of people experiencing hangs when copying > large amounts of data with kswapd using a large amount of CPU which > appear to be due to recent reclaim changes. > > SLUB using high orders is the trigger but not the root cause as SLUB > has been using high orders for a while. The following four patches > aim to fix the problems in reclaim while reducing the cost for SLUB > using those high orders. > > Patch 1 corrects logic introduced by commit [1741c877: mm: > kswapd: keep kswapd awake for high-order allocations until > a percentage of the node is balanced] to allow kswapd to > go to sleep when balanced for high orders. > > Patch 2 prevents kswapd waking up in response to SLUBs speculative > use of high orders. > > Patch 3 further reduces the cost by prevent SLUB entering direct > compaction or reclaim paths on the grounds that falling > back to order-0 should be cheaper. > > Patch 4 notes that even when kswapd is failing to keep up with > allocation requests, it should still go to sleep when its > quota has expired to prevent it spinning. This all works fine for me ... three untar runs and no kswapd hangs or pegging the CPU at 99% ... in fact, kswapd rarely gets over 20% This isn't as good as the kswapd sleeping_prematurely() throttling patch. For total CPU time on a three 90GB untar run, it's about 64s of CPU time with your patch rather than 6s, but that's vastly better than the 15 minutes of CPU time kswapd was taking even under PREEMPT. James -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxxx For more info on Linux MM, see: http://www.linux-mm.org/ . Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/ Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>